8261 Datasheet, PDF (1/4 Pages) Filtran LTD – LAN 10/100 Base-T Single Port Transformer Module

MSD HVC-2 Coil
PN 8261
ONLINE PRODUCT REGISTRATION: Register your MSD product online. Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.
Parts Included
1 - HVC-2 Coil
4 - Vibration Mounts and Hardware
2 - Brass Lock Washers
2 - Ring Lug Terminals
2 - Brass Screws
WARNING: Disconnect the battery during installation. When disconnecting the battery, always
remove the negative cable first and install it last.
The HVC-2 Coil is designed to be used with an MSD 7, 8 or 10 Series Ignition Control only.
It is recommended to use 14-Gauge wiring for the primary coil wiring.
INSTALLATION
1. The Coil can be mounted in any position, but should be away from direct heat sources.
Use the Coil as a template and mark the location of the mounting holes. Use an 3/16” bit
to drill the holes.
2. Install the supplied vibration mounts to the coil and install the coil.
3. The MSD Orange wire connects to coil positive (+). Black connects to coil negative (-).
Note: It is recommended to use 14-Gauge wiring for the primary coil wiring.
4. Connect the coil secondary wire to the coil and distributor cap.
WARNING: Very high voltages are present at the coil when the engine is running. Never connect
any test equipment or touch the coil while the engine is cranking or running.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]