8250 Datasheet, PDF (1/2 Pages) 3M Electronics – D Sub Plug Connector, 50 Position

MSD HVC Coil
PN 8250
ONLINE PRODUCT REGISTRATION: Register your MSD product online. Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.
Parts Included:
1 - Power-Core HVC Coil
4 - Vibration Mounts
1 - 2-Pin Weathertight Connector and Harness
1 - 2-Pin Weathertight Connector Assembly
1 - 4" Black Wire
2 - Rings Lug Terminals
2 - Nuts and Washers
2 - 45° Blade Terminals
2 - Spade Terminals
2- Star Washers
WARNING: Disconnect the battery during installation. When disconnecting the battery, always
remove the negative cable first and install it last.
WARNING: Very high voltages are present at the coil when the engine is running. Never connect
any test equipment or touch the coil while the engine is running.
The HVC Coil is designed to be used exclusively with the MSD 6HVC Series Ignition Controls.
This Coil is not recommended for use with any other MSD Ignition Control or similar
aftermarket ignition.
INSTALLATION
1. The Coil can be mounted in any position, but should be away from direct heat sources.
Use the Coil as a template and mark the location of the mounting holes. Use an 1/8” bit
to drill the holes.
2. Install the supplied vibration mounts to the coil and install the coil. Also install one end of
the 4” Black wire between a vibration mount and the bracket. Connect the other end to
ground.
Note: The supplied star washers must be used on both sides of the ground wire ring lug
terminal. This ensures proper grounding through the anodized brackets.
3. Install the supplied 2-pin harness and connect the Orange to coil positive(+) and Black
to Coil negative(-).
4. Connect the coil secondary wire to the coil and distributor cap.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]