8239 Datasheet, PDF (1/2 Pages) Mallory performance club – MSD Blaster Mitsubishi/Neon Coil Pack

MSD Blaster Mitsubishi/Neon Coil Pack
PN 8239
ONLINE PRODUCT REGISTRATION: Register your MSD product online. Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.
IMPORTANT: Read instructions before attempting the installation.
Parts Included:
1 - Blaster Coil
WARNING: During installation, disconnect the battery cables. When disconnecting the battery,

always remove the Negative cable first and install it last.
The MSD Blaster Coil is designed as a replacement coil and produces a high voltage spark. To get
even more ignition performance, install an MSD DIS-2 Ignition Control, PN 62112.
There are two types of 4-tower coils used on the Eclipse, Neon, Talon and other vehicles. Figure 1
shows the difference between the two. The MSD Coil, PN 8239 has flat terminal pins, if you require a
coil with round terminal pins, an Adapter can be ordered from Mopar Dealers as PN M04897087AA,
or call the MSD Customer Service line at [phone], ask for Adapter, ASY30160.
PN 8239
12V
12V
ROUND
TERMINAL PINS
FLAT
TERMINAL PINS
Figure 1 The difference between round and flat terminal coils.
WARNING: High Voltage is present on the coil terminals. DO NOT touch the coil terminals or

tower when the engine is cranking or running.
1. Disconnect the stock coil connector and note the position of the plug wires before removing the
wires.
2. Remove the four mounting bolts and remove coil.
3. Install the new MSD Blaster Coil and retaining screws.
4. Plug in the wiring harness and connect the coil wires.
M S D  •  WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]