564R Datasheet, PDF (1/4 Pages) Mallory performance club – MAGNETIC BREAKERLESS CONVERSION KIT FOR MALLORY DISTRIBUTORS

FORM #1321 (REV. B) 8/99
INSTALLATION INSTRUCTIONS
®
MAGNETIC BREAKERLESS
CONVERSION KIT
FOR MALLORY DISTRIBUTORS
IMPORTANT
This conversion kit must be used with an ignition ballast resistor (or loom
resistance wire) to prevent module failure. If your vehicle is not equipped
with a ballast resistor or loom resistance wire, Mallory Ballast Resistor (Part
No. 700) may be used.
APPLICATIONS
NOTE: These kits do not work with vacuum advance distributors.
Part No. 564-R
Part No. 564-L
Mallory 8 cylinder point distributors (automotive and marine) which use a
standard stack cap (Part No. 209 or 209D) and rotate clockwise (RH)
Mallory 8 cylinder point distributors (automotive and marine) which use a
standard stack cap (Part No. 209 or 209D) and rotate clockwise (LH)
NOTE: These kits will only work in distributors which use a “YH” advance mechanism. Look
for an “H” at the end of the part number located on a tag on the distributor bowl.
PARTS INCLUDE IN THIS KIT:
1 Sleeve/Plate Assembly
1 Magnetic Module
1 Rotor
1 Bag Hardware
INSTALLATION
Step 1
Remove the cap and rotor, then remove the
condensor.
Step 2
Remove the plastic insulators (see Figure 1).
Step 3
Loosen the 2 nuts that hold the cap clips/brackets in
place (see Figure 1). NOTE: To loosen the nuts on
a marine distributor, the aluminum pins in the
brackets may need to be cut in two and removed.
Replacement pins are provided.
Step 4
Remove the point plate assembly by lifting it out of
the housing (see Figure 1).
Step 5
See Figure 2.
Remove the advance springs. Remove the two E-
clips. Remove the advance weights and bushings.
Step 6
Lift the sleeve and advance plate up and off the
distributor shaft.
NOTE: Between the distributor shaft drive plate and
the advance plate is a thrust washer. Sometimes
the thrust washer sticks to the bottom of the ad-
vance plate during removal of the sleeve and
advance plate. Make sure you install the thrust
washer on the distributor shaft drive plate. A re-
placement thrust washer is provided if your thrust
washer needs replacement.
0