4060FI Datasheet, PDF (1/4 Pages) Mallory performance club – ELECTRIC FUEL PUMP

INSTALLATION INSTRUCTIONS
FORM 1061 (REV. F) 11/04
COMP PUMP^® SERIES 60FI
ELECTRIC FUEL PUMP
PART NO. 4060FI
NOTE: DO NOT RUN THIS PUMP WITHOUT FUEL (EXCEPT FOR BRIEF PERIODS WHILE PRIMING).
PARTS INCLUDED IN THIS KIT
4 Nuts, 5/16" – 24
4 Washers, Steel 5/16" Flat
4 Bolts, Steel 5/16"
1 Ring Terminal
1 Fuse, 7.5 AMP
1 Fuse Holder
GENERAL INFORMATION
The COMP PUMP^® 60FI Series Electric Fuel Pump
is a high pressure fuel pump designed for fuel
injection applications. This fuel pump must be used
with return style (bypass) fuel pressure regulators.
Using this fuel pump with any other kind of fuel
pressure regulator (or no regulator) will result in
severe fuel pump damage, and will void the product
warranty.
At the bottom of the fuel pump is an air bleed system
designed to help in priming the fuel pump. The air
bleed line is plumbed to the fuel return line. If the fuel
pressures you are running are 10 PSI or less, put a
1/8 NPT plug in the air bleed port.
Be sure to install a suitable fuel filter (maximum 100
micron filtration) between the fuel tank and the fuel
pump. This prevents debris from becoming wedged
in the fuel pump’s Gerotor and locking it.
An additional fuel filter (maximum 10 micron, such
as the Mallory 160 Series COMP FILTER^® Part
No. 3160) must be placed between the fuel pump
and the injectors. This prevents debris from clogging
the injectors.
SPECIFICATIONS
Maximum recommended operating pressure:
55 psi continuous, 65 psi intermittent
Minimum oil pressure switch current rating: 7.5 amps
Fuel pump over current protection: 7.5 amp fuse
Fuel application: Gasoline
This product is covered under one or more of the
following U.S. patents: 5,007,806; 4,998,557;
5,111,793; 5,123,436; 5,186,147.
SERVICE PARTS
Brush Kit
Seal and Repair Kit
3146A
3165
MALLORY IGNITION
www.mrgasket.com
1