29450 Datasheet, PDF (1/2 Pages) Mallory performance club – PROMASTER IGNITION COIL

INSTALLATION INSTRUCTIONS
FORM 1528 (REV. B) 02/04
PROMASTER^® IGNITION COIL
PART NO. 29450
LIST OF PARTS:
1 Ignition Coil
1 Ignition Coil Bracket Part No. 29227
1 Screw, #10 x 1"
1 Coil Wire Boot
1 Coil Wire Terminal
2 Ring Terminals
3 Screws, #10 x 3/4"
GENERAL INFORMATION
Check the ignition coil application to be sure it is being
used in the proper application for optimum performance.
Spark Plug Wires and Coil Wire
To prevent false triggering and possibility of premature
ignition failures, use suppression type spark plug wire.
We recommend spiral core ignition wire, such as Mallory
PRO SIDEWINDER^® 8MM Suppression Ignition Wire or
carbon core ignition wire, such as Mallory PRO WIRE^® 8MM
Suppression Ignition Wire or Mallory SPRINT WIRE^® 8MM
Suppression Ignition Wire.
If your coil wire will not reach between the distributor cap
and the ignition coil, we suggest using one of the Mallory
Spark Plug Wire Replacement Kits. The Mallory Spark Plug
Wire Replacement Kit is a 4 ft. length of 8mm Silicone
Jacketed Suppression Wire assembled with a straight spark
plug boot and terminal on one end, and a 90° spark plug
boot and terminal on one end. Supplied with male (HEI),
and female socket type distributor boots and terminals that
make these kits ideal for remote mounting an ignition coil.
Mallory Spark Plug Wire Replacement Kits
• Part No. 919, PRO SIDEWINDER^® 8MM Suppression
Ignition Wire (red)
Spark Plug Gaps
For street applications, use your engine manufacturer’s
specifications. For racing applications, start with your
engine manufacturer’s specifications, then experiment
with, and closely monitor, various gaps to achieve
maximum performance.
MOUNTING PROCEDURE
Ignition coils should be mounted on a flat surface as close
as possible to the distributor and away from extreme heat
from engine components. DO NOT mount ignition coils to
the engine.
Step 1
PROMASTER^® Ignition Coils may be mounted at any angle.
Find a suitable flat surface to mount the ignition coil.
Step 2
Center punch the mounting pattern using the ignition coil
bracket as a template to mark locations for drilling holes.
Drill holes using a 9/64" drill bit.
Step 3
Mount the ignition coil bracket using three #10 x 3/4"
screws.
Step 4
Slide the ignition coil into the ignition coil bracket. Mount
the ignition coil in the ignition coil bracket with the #10 x 1"
screw.
COIL WIRE INSTALLATION
Step 1
Strip 5/8" of insulation from the coil wire. Fold the core over
the outside of the coil wire.
Step 2
Put the coil wire terminal on the end of the coil wire and
crimp the connection.
Step 3
Slide the coil wire into the coil wire boot. Install the coil wire
on the high voltage terminal. See Figure 1.
WIRING PROCEDURE
See page 2 for wiring diagrams and information
NOTE: This coil is not optimized for use with after-
market ignition controls, such as the Mallory HYFIRE^®.
If you are using an aftermarket ignition control,
please contact our customer service department at
216.688.8300 for information on proper coil application.
MALLORY IGNITION
www.mrgasket.com
1