29351 Datasheet, PDF (1/1 Pages) Mallory performance club – ACTIVE POWER FILTER

INSTALLATION
INSTRUCTIONS
ACTIVE POWER FILTER
PART NO. 29351
Parts Included in this kit:
1 Active Power Filter
1 Velcro^® Hook and Loop, 1" x1-1/2"
GENERAL INFORMATION
The Active Power Filter is designed for UNILITE^® and MBI Ignition
Systems that experience failures with the ignition modules from voltage
spikes (voltage transients, power surges). Voltage spikes are associated
with “noisy” electrical systems from electrical defects such as worn
alternator brushes, corroded or oxidized electrical connections and similar
electrical problems. Voltage spikes are clamped and regulated by the
Active Power Filter from damaging the UNILITE^® Ignition Module.
NOTE: The Active Power Filter does not resolve failures with MBI
and UNILITE^® Ignition Modules associated with: a) the absence of an
ignition ballast resistor in applications that require an ignition ballast
resistor; b) improper wiring.
INSTALLATION PROCEDURE
Step 1
Disconnect the distributor female connector from the distributor wire har-
ness male connector.
Step 2
Connect the distributor female connector to the Active Power Filter male
connector. See Figure 1.
Step 3
Connect the Active Power Filter female connector to the distributor wire har-
ness male connector. See Figure 1.
Step 4
Mount the Active Power Filter to the distributor housing with Velcro^®.
Figure 1
DISTRIBUTOR (TYPICAL)
ALL UNILITE^® DISTRIBUTOR SERIES NOS. 37, 38, 45, 46, 47, 83, 86, 91, AND 93
ALL UNILITE^® BREAKERLESS ELECTRONIC CONVERSION KITS
ALL MBI DISTRIBUTOR SERIES 42, 50, 57 AND 87
ALL MBI BREAKERLESS ELECTRONIC CONVERSION KITS
DISTRIBUTOR
FEMALE
CONNECTOR
(MOUNTING LOCATION SUGGESTION)
MALE
CONNECTOR
ACTIVE
POWER
FILTER
FEMALE
CONNECTOR
DISTRIBUTOR WIRE HARNESS
NOTE: THE DISTRIBUTOR WIRE HARNESS REMAINS
CONNECTED ACCORDING TO THE INSTRUCTIONS
SUPPLIED WITH YOUR IGNITION SYSTEM.
MALE
CONNECTOR
MALLORY IGNITION IS A DIVISION OF THE MR. GASKET PERFORMANCE GROUP
550 MALLORY WAY, CARSON CITY, NV 89701
[phone]
FAX [phone]
www.mrgasket.com
FORM 1359
(REV. C) 7/03
MADE IN U.S.A.
PRINTED IN U.S.A.