910-A1A0-003 Datasheet, PDF (4/4 Pages) Magnetrol International, Inc. – Echotel® Model 910 Ultrasonic Level Switch

AGENCY APPROVALS
AGENCY
FM
MODEL APPROVED
910-XXXX-XXX
APPROVAL CATEGORY
Explosion Proof
910-XXXX-XXX
Non-Incendive
CSA
910-XXXX-XXX
Explosion Proof
910-XXXX-XXX
Non-Incendive
ATEX
910-5XXX-XXX
910-PXXX-XXX
APPROVAL CLASSES
Class I, Div. 1; Groups B, C & D
Class II, Div. 1; Groups E, F, & G
Class III, NEMA Type 4X, T6
Class I, Div. 2; Groups A, B, C, & D
Class II, Div. 2; Groups F & G
Class III, NEMA Type 4X, T5
Class I, Div. 1; Groups C & D
Class II, Div. 1; Group E, F, & G
Class III, Type 4X, T6
Class I, Div. 2; Groups A, B, C, & D
Class II, Div. 2; Groups E, F, & G
Class III, Type 4X, T5
II 1/2 G EEx d II C T6 / EEx e II T6
Note: Consult factory for Brazilian INMETRO BR-Ex d IIC T6 IP66 approval.
These units have been tested to EN 50081-2
and EN 50082-2 and are in compliance with
the EMC Directive 89/336/EEC.
DIMENSIONAL SPECIFICATIONS
INCHES (MM)
4.63
(117) Dia.
3.00 Rotation
(76) clearance
4.48
(113)
6.25
(158)
3/4" NPT
tank connection
2.75
(70)
3/4" NPT _3.50
Optional ⁽⁸⁸⁾
mounting
flange
Actuation length ➀➁
Actuation point ^{.25 (6)}
.875 (22) Dia.
4.63
(117) Dia.
3.44 (87)
Rotation clearance
4.63
(117) Dia.
3.44 (87)
Rotation clearance
4.63
(117) Dia.
3.44 (87)
Rotation clearance
3/4" NPT
plugged
4.48
(113)
6.25
(158)
3/4" NPT
tank connection
3/4" NPT
Optional
mounting
flange
2.75
(70)
3.50
(88)
3/4" NPT
4.48 ^plugged
(113)
6.25
158)
Actuation length ➀➁
1" BSP
tank connection
2.75
(70)
3/4" NPT
Actuation length ➁
3/4" NPT
(plugged)
4.48
(113)
.25 (6)
2.75
(70)
3/4" NPT
Actuation
length ➀➁
Actuation point .25 (6)
.875 (22) Dia.
Actuation point .25 (6)
.875 (22) Dia.
Actuation point ^{.25 (6)}
.875 (22) Dia.
NEMA 4X/7/9, 316 SS hsg
3_{⁄4" NPT single conduit}
NEMA 4X/7/9, aluminum hsg
3_{⁄4" NPT dual conduits}
NEMA 4X/7/9, aluminum hsg
3_{⁄4" NPT dual conduit}
(w/1" BSP process conn.)
NEMA 4X/7/9, aluminum hsg
3_{⁄4" NPT dual conduit}
(with hygienic flange)
QUALITY
All Magnetrol Model 910 Level Switches are war-
ranted free of defects in materials or workman-
ship for two full years from the date of original
factory shipment.
If returned within the warranty period; and,
upon factory inspection of the control, the
cause of the claim is determined to be covered
under the warranty; then, Magnetrol will repair
or replace the control at no cost to the pur-
chaser (or owner) other than transportation.
Magnetrol shall not be liable for misapplication,
labor claims, direct or consequential damage or
expense arising from the installation or use of
equipment. There are no other warranties
expressed or implied, except special written
warranties covering some Magnetrol products.
For additional information, see Instruction Manual 51-604.
5300 Belmont Road • Downers Grove, Illinois 60515-4499 • 630-969-4000 • Fax [phone] • www.magnetrol.com
145 Jardin Drive, Units 1 & 2 • Concord, Ontario Canada L4K 1X7 • 905-738-9600 • Fax [phone]
Heikensstraat 6 • B 9240 Zele, Belgium • 052 45.11.11 • Fax [phone]
Regent Business Ctr., Jubilee Rd. • Burgess Hill, Sussex RH15 9TL U.K. • 01444-871313 • Fax [phone]
Copyright © 2011 Magnetrol International, Incorporated. All rights reserved. Printed in the USA.
Performance specifications are effective with date of issue and are subject to change without notice.
Magnetrol & Magnetrol logotype and Echotel® are registered trademarks of Magnetrol International.
Tri-Clamp® is a registered trademark of Ladish Co.
Tri-Clover® is a registered trademark of Tri-Clover, Inc.
BULLETIN: 51-105.17
EFFECTIVE: February 2011
SUPERSEDES: July 2010