805-501A-110 Datasheet, PDF (4/4 Pages) Magnetrol International, Inc. – Kotron® Model 805 Smart RF Level Transmitter

AGENCY APPROVALS
AGENCY
FM
MODEL APPROVED
805-5XXX-11X
APPROVAL CATEGORY
Intrinsically Safe
805-5XXX-11X
Non-Incendive
CSA
805-5XXX-110
Intrinsically Safe
805-5XXX-110
Suitable for:
ATEX
805-5XXX-A1X
Intrinsically Safe
QUALITY
APPROVAL CLASSES
Class I, Div. 1; Groups A, B, C, & D
Class II, Div. 1; Groups E, F, & G
Class III
T4 Ta = +71° C
Entity
NEMA 4X IP66
Class I, Div. 2; Groups A, B, C, & D
Class II, Div. 2; Groups F & G
Class III
T4 Ta = +71° C
NEMA 4X IP66
Class I, Div. 1; Groups A, B, C, & D
Class II, Div. 1; Groups E & F (insulated probes)
Class II, Div. 1; Group G (bare or insulated probes)
Class III
T4 Ta = +71° C
Entity
Type 4X
Class I, Div. 2; Groups A, B, C, & D
Class II, Div. 1; Groups E & F (insulated probes)
Class II, Div. 1; Group G (bare or insulated probes)
Class III
T4 Ta = +71° C
Type 4X
II 1G EEx ia IIC T6
(-40° to +40° C ambient temp.)
II 1G EEx ia IIC T4
(-40° to +80° C ambient temp.)
These units have been tested to EN 50081-2
and EN 50082-2 and are in compliance with
the EMC Directive 89/336/EEC.
The quality assurance system in place at Magnetrol guar-
antees the highest level of quality throughout the com-
pany. Magnetrol is committed to providing full customer
satisfaction both in quality products and quality service.
The Magnetrol quality assurance system is registered to
ISO 9001 affirming its commitment to known interna-
tional quality standards providing the strongest assur-
ance of product/service quality available.
ESP
Expedite
Ship
Plan
Kotron Smart RF Model 805 Transmitters are available for
quick shipment, usually within one week after factory
receipt of a purchase order, through the Expedite Ship
Plan (ESP).
Models covered by ESP service are conveniently color
coded in the selection data charts.
WARRANTY
To take advantage of ESP, simply match the color coded
model number codes (standard dimensions apply).
ESP service may not apply to orders of ten units or more.
Contact your local representative for lead times on larger
volume orders, as well as other products and options.
All Magnetrol electronic level and flow
controls are warranted free of defects in materials or
workmanship for one full year from the date of original
factory shipment.
If returned within the warranty period; and, upon factory
inspection of the control, the cause of the claim is deter-
mined to be covered under the warranty; then,
Magnetrol will repair or replace the control at no cost to
the purchaser (or owner) other than transportation.
Magnetrol shall not be liable for misapplication, labor
claims, direct or consequential damage or expense aris-
ing from the installation or use of equipment. There are
no other warranties expressed or implied, except special
written warranties covering some Magnetrol products.
For additional information, see Instruction Manual 50-660.
5300 Belmont Road • Downers Grove, Illinois 60515-4499 • 630-969-4000 • Fax [phone] • www.magnetrol.com
145 Jardin Drive, Units 1 & 2 • Concord, Ontario Canada L4K 1X7 • 905-738-9600 • Fax [phone]
Heikensstraat 6 • B 9240 Zele, Belgium • 052 45.11.11 • Fax [phone]
Regent Business Ctr., Jubilee Rd. • Burgess Hill, Sussex RH15 9TL U.K. • 01444-871313 • Fax [phone]
Copyright © 2010 Magnetrol International, Incorporated. All rights reserved. Printed in the USA.
Performance specifications are effective with date of issue and are subject to change without notice.
Magnetrol, Magnetrol logotype and Kotron are registered trademarks of Magnetrol International
CSA logotype is a registered trademark of Canadian Standards Association, HART is a registered trademark of the HART Communication Foundation,
Halar is a registered trademark of Allied Chemical Corp, Hastelloy is a registered trademark of Haynes International, Inc.,
Kynar is a registered trademark of Arkema, Inc, Teflon is a registered trademark of DuPont
BULLETIN: 50-160.6
EFFECTIVE: December 2010
SUPERSEDES: December 2005