408-8777 Datasheet, PDF (5/5 Pages) Tyco Electronics – PRO–CRIMPER III Hand Crimping Tool

PRO-CRIMPER III Hand Crimping Tool Assembly 91367-1
408-8777
5. Make a sample crimp and measure the crimp
height. If the dimension is acceptable, replace and
secure the lockscrew. If the dimension is
unacceptable, continue to adjust the ratchet, and
again measure a sample crimp.
8. MAINTENANCE
Ensure that the tool and dies are clean by wiping
them with a clean, soft cloth. Remove any debris with
a clean, soft brush. Do not use objects that could
damage the tool. When not in use, keep handles
closed to prevent objects from becoming lodged in
the crimping dies, and store in a clean, dry area.
9. VISUAL INSPECTION
The crimping dies should be inspected on a regular
basis to ensure that they have not become worn or
damaged. Inspect the crimp sections for flattened,
chipped, worn, or broken areas. If damage or
abnormal wear is evident, the tool must be replaced.
See Section 10, REPLACEMENT.
10. REPLACEMENT
Customer–replaceable parts are shown in Figure 1.
Available separately, PRO–CRIMPER III Hand Tool
Repair Kit 679221–1 includes a replacement nut and
a variety of pins, rings, screws, and springs. If the
dies are damaged or worn excessively, they must be
replaced. Order the repair kit and replaceable parts
through your Tyco Electronics Representative, or call
1–800–526–5142, or send a facsimile of your
purchase order to 1–717–986–7605, or write to:
Customer Service (38–35)
Tyco Electronics Corporation
P.O. Box 3608
Harrisburg, PA 17105–3608
Tools may also be returned to for evaluation and
repair. For tool repair service, contact a Tyco
Electronics Representative at 1–800–526–5136.
11. REVISION SUMMARY
Since the previous release, the TE logo was applied
and the format was updated.
Rev A
Tyco Electronics Corporation
5 of 5