|
408-8776 Datasheet, PDF (5/5 Pages) Tyco Electronics – PRO–CRIMPER III Hand Crimping Tool | |||
|
◁ |
PRO-CRIMPER III Hand Crimping Tool Assembly 91369-1
408-8776
9. VISUAL INSPECTION
The crimping dies should be inspected on a regular
basis to ensure that they have not become worn or
damaged. Inspect the crimp sections for flattened,
chipped, worn, or broken areas. If damage or
abnormal wear is evident, the tool must be replaced.
See Section 10, REPLACEMENT.
10. REPLACEMENT
Customerâreplaceable parts are shown in Figure 1.
Available separately, PROâCRIMPER III Hand Tool
Repair Kit 679221â1 includes a replacement nut and
a variety of pins, rings, screws, and springs. If the
dies are damaged or worn excessively, they must be
replaced. Order the repair kit and replaceable parts
through your Tyco Electronics Representative, or call
1â800â526â5142, or send a facsimile of your
purchase order to 1â717â986â7605, or write to:
CUSTOMER SERVICE (38â35)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105â3608
Tools may also be returned to for evaluation and
repair. For tool repair service, contact a Tyco
Electronics Representative at 1â800â526â5136.
11. REVISION SUMMARY
Since the previous release of this instruction sheet,
the TE logo was applied.
Rev A
Tyco Electronics Corporation
5 of 5
|