|
408-4217 Datasheet, PDF (5/5 Pages) Tyco Electronics – PRO–CRIMPER III Hand Crimping Tool Assembly | |||
|
◁ |
PRO-CRIMPER III Hand Crimping Tool Assembly 318451-1
408-4217
7. MAINTENANCE
Ensure that the tool and dies are clean by wiping
them with a clean, soft cloth. Remove any debris with
a clean, soft brush. Do not use objects that could
damage the tool. When not in use, keep handles
closed to prevent objects from becoming lodged in
the crimping dies, and store in a clean, dry area.
8. REPLACEMENT
Customerâreplaceable parts and dies are shown in
Figure 8. Spare parts or the die assembly should be
stocked and controlled to prevent lost time when die
replacement is necessary.
Available separately, PROâCRIMPER III Hand
Crimping Tool Repair Kit 679221â1 includes a
replacement nut and a variety of pins, rings, screws,
and springs.
Order replaceable parts through your Tyco
Electronics Representative, or call 1â800â526â5142,
or send a facsimile of your purchase order to
1â717â986â7605, or write to:
CUSTOMER SERVICE (38â35)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105â3608
For customer repair service, contact a Tyco
Electronics Representative at 1â800â526â5136.
9. REVISION SUMMARY
Since the previous release of this instruction sheet,
the following change were made:
S TE logo was applied; and
S The format was updated to the current
corporate requirements.
1
3
2.64 +0.20
[.104 +.008]
g1.04-1.17
[.041-.046]
4
4.32 +0.10
[.170 +.004]
2
5
gOne side can go 0.064 [.0025] out of tolerance as long as the average
measurements of both sides are within dimension specified.
11.63
[.458]
CUSTOMER-REPLACEABLE PARTS FOR DIE ASSEMBLY 318451-2
ITEM
PART NUMBER
DESCRIPTION
1
318432-1
INDENTER, Wire
2
318430-1
ANVIL, Wire
3
318431-2
INDENTER, Insulation
4
318429-2
ANVIL, Insulation
5
679231-1
PIN, Die Retaining
Figure 8
47.62
[1.88]
Weight: 227 g [8 oz]
QTY PER
ASSEMBLY
1
1
1
1
4
Rev B
Tyco Electronics Corporation
5 of 5
|