|
408-4147 Datasheet, PDF (5/6 Pages) Tyco Electronics – The head must be installed in Pistol Grip Manual Handle Assembly | |||
|
◁ |
Terminating Head 58246-3
408-4147
6. MAINTENANCE AND INSPECTION
6.1. Daily Maintenance
1. Remove dust, moisture, and other contaminants
with a clean, soft brush or lintâfree cloth. DO NOT
use objects that could damage the head.
2. Make sure that all components are in place and
properly secured.
3. Actuate the tool to make sure that the
mechanisms inside the head function smoothly.
6.2. Periodic Maintenance
1. Remove any accumulated film with a suitable
cleaning agent that will not affect plastic.
2. Make sure all components are in place and
properly secured.
3. Check for chipped, cracked, worn, or broken
areas on the head. If damage is evident, repair or
replace the head.
6.3. Inspection
Regular inspections should be performed by quality
control personnel with a record of quality control
inspections remaining with the personnel responsible
for the head. One inspection per month is the
recommended frequency; however, operator training
and skill, amount of use, working conditions, and
established company standards are all factors to be
considered in establishing inspection frequency.
7. REPLACEMENT AND REPAIR
Customerâreplaceable parts are listed in Figure 7.
A complete inventory should be stocked and
controlled to prevent lost time when replacement of
parts is necessary. Parts other than those listed
should be replaced by Tyco Electronics Corporation
to ensure quality and reliability. Order replacement
parts through your representative, or call
1â800â526â5142, or send a facsimile of your
purchase order to 717â986â7605, or write to:
CUSTOMER SERVICE (038â035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105â3608
For customer repair service, call 1â800â526â5136.
8. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated document to corporate requirements
S Removed connector part numbers
S Modified Figure 3
S Modified Step 5 of Paragraph 3.1 and Point 1
of Paragraph 3.2
S Modified Step 2 of Section 4
S Replaced address for customer repair service
with phone number
Rev A
Tyco Electronics Corporation
5 of 6
|
▷ |