|
408-4075 Datasheet, PDF (5/5 Pages) Tyco Electronics – PRO–CRIMPER III Hand Crimping Tool | |||
|
◁ |
PRO-CRIMPER III Hand Crimping Tool Assembly 58564-1
408-4075
8. MAINTENANCE
Ensure that the tool and dies are clean by wiping
them with a clean, soft cloth. Remove any debris with
a clean, soft brush. Do not use objects that could
damage the tool. When not in use, keep handles
closed to prevent objects from becoming lodged in
the crimping dies, and store in a clean, dry area.
9. VISUAL INSPECTION
The crimping dies should be inspected on a regular
basis to ensure that they have not become worn or
damaged. Inspect the crimp sections for flattened,
chipped, worn, or broken areas. If damage or
abnormal wear is evident, the tool must be replaced.
See Section 10, REPLACEMENT.
CUSTOMER SERVICE (38â35)
TYCO ELECTRONICS
PO BOX 3608
HARRISBURG PA 17105â3608
11.REVISION SUMMARY
Since the previous release of this instruction sheet,
the following changes were made
S TE logo was applied;
S PROâCRIMPER II was changed to
PROâCRIMPER III; and
S The format was updated to the current
corporate requirements.
10. REPLACEMENT
Customerâreplaceable parts are shown in Figure 1.
Available separately, PROâCRIMPER III Hand
Crimping Tool Repair Kit 679221â1 includes a
replacement nut and a variety of pins, rings, screws,
and springs. If the dies are damaged or worn
excessively, they must be replaced. Order the repair
kit and replaceable parts through your Tyco
Electronics representative, or call 1â800â526â5142,
or send a facsimile of your purchase order to
1â717â986â7605, or write to:
Rev B
Tyco Electronics Corporation
5 of 5
|