MAALSS0025 Datasheet, PDF (4/4 Pages) Tyco Electronics – High Dynamic Range Low Noise Amplifier, 400 - 500 MHz

High Dynamic Range Low Noise Amplifier,
400 - 500 MHz
SO-8
MAALSS0025
V1
Recommended PCB Configuration
Cross Section View
RF Traces & Components
RF Ground
DC Routing
Customer Defined
The PCB dielectric between RF traces and RF ground
layers should be chosen to reduce RF discontinuities
between 50-ohm lines and package pins. M/A-COM
recommends an FR-4 dielectric thickness of 0.008” (0.20
mm) yielding a 50-ohm line width of 0.015” (0.38 mm).
The recommended RF metalization thickness is 1 ounce
copper.
4
M/A-COM Inc. and its affiliates reserve the right to make changes to the
product(s) or information contained herein without notice. M/A-COM makes
no warranty, representation or guarantee regarding the suitability of its
products for any particular purpose, nor does M/A-COM assume any liability
whatsoever arising out of the use or application of any product(s) or
information.
• North America Tel: [phone] / Fax: [phone]
• Europe Tel: [phone] / Fax: [phone]
• Asia/Pacific Tel: [phone] / Fax: [phone]
Visit www.macom.com for additional data sheets and product information.