408-9450 Datasheet, PDF (4/5 Pages) Tyco Electronics – Read these and all referenced instructions thoroughly before using the head.

Terminating Head 58392-1
Feed Slide
Locating
Pawl
Wire
408-9450
Index Rib of
Connector
Tool Base
Left Side
of Head
Funnel Area
Pistol Grip Handle
Assembly (Manual Shown)
Figure 5
2. Make sure all components are in place and
properly secured.
3. Check for chipped, cracked, worn, or broken
areas on the head. If damage is evident, repair or
replace the head.
6.3. Inspection
Regular inspections should be performed by quality
control personnel with a record of quality control
inspections remaining with the personnel responsible
for the head. One inspection per month is the
recommended frequency; however, operator training
and skill, amount of use, working conditions, and
established company standards are all factors to be
considered in establishing inspection frequency.
7. REPLACEMENT AND REPAIR
Customer–replaceable parts are listed in Figure 6.
A complete inventory should be stocked and
controlled to prevent lost time when replacement of
parts is necessary. Parts other than those listed
should be replaced by Tyco Electronics Corporation
to ensure quality and reliability. Order replacement
parts through your representative, or call
1–800–526–5142, or send a facsimile of your
purchase order to 717–986–7605, or write to:
CUSTOMER SERVICE (038–035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105–3608
For customer repair service, call 1–800–526–5136.
8. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated document to corporate requirements
S Removed connector part number
S Corrected reference to application specification
S Added connectors to Figure 1
S Added wire sizes and connector color code
S Modified Figure 3
S Modified Step 2 of Section 4
S Modified Step 5 of Paragraph 3.1 and Point 1
of Paragraph 3.2
S Added phone number for customer repair
service
4 of 5
Tyco Electronics Corporation
Rev B