408-4276 Datasheet, PDF (4/5 Pages) Tyco Electronics – PRO–CRIMPER III Hand Crimping Tool Assembly

PRO-CRIMPER III Hand Crimping Tool Assembly 58612-1
408-4276
CAUTION
!
Make sure that both sides of the insulation barrel
are started evenly into the crimping section. Do
NOT attempt to crimp an improperly positioned
contact.
4. Hold the contact in position and squeeze the
tool handles together until ratchet engages
sufficiently to hold the contact in position. Do NOT
deform insulation barrel or wire barrel.
5. Insert stripped wire into contact insulation and
wire barrels until it is butted against the wire stop,
as shown in Figure 3.
6. Holding the wire in place, squeeze tool handles
together until ratchet releases. Allow tool handles
to open and remove crimped contact.
NOTE
i
The crimped contact may stick in the crimping
area, but the contact can be easily removed by
pushing downward on the top of the locator (see
Figure 3).
Position Point
on Center of
Wire Barrel
Opposite
Seam
Modified Anvil
A"
WIRE SIZE
mm² (MAX)
1.0
0.6
0.35
CRIMP SECTION
(WIRE SIZE MARKING)
1.0
0.6
0.35
Figure 4
CRIMP HEIGHT
DIM. (A) AND
TOLERANCE (+)
" 1.50
" [.059
.05
.002]
" 1.32
" [.052
.05
.002]
" 1.22
" [.048
.05
.002]
7. Check the contact’s crimp height as described in
Section 6, CRIMP HEIGHT INSPECTION. If
necessary, adjust the crimp height as described in
Section 7, CRIMP HEIGHT ADJUSTMENT.
6. CRIMP HEIGHT INSPECTION
This inspection requires the use of a micrometer with
a modified anvil.
7. RATCHET (Crimp Height) ADJUSTMENT (Figure 5)
1. Remove the lockscrew from the ratchet
adjustment wheel.
2. With a screwdriver, adjust the ratchet wheel
from the locator side of the tool.
Screwdriver
NOTE
i
Tyco Electronics does not manufacture or market
these gages,. TE recommends the the use of the
modified micrometer (Crimp Height Comparator
RS-1019-5LP) OR the digital Mitutoyo
micrometer.
Proceed as follows:
1. Refer to Figure 4 and select a wire (maximum
size) for each crimp section listed.
2. Refer to Section 5, CRIMPING PROCEDURE,
and crimp the contact(s) accordingly.
3. Using a crimp height comparator, measure the
wire barrel crimp height as shown in Figure 4. If the
crimp height conforms to that shown in the table,
the tool is considered dimensionally correct. If not,
the tool must be adjusted. Refer to Section 7,
CRIMP HEIGHT ADJUSTMENT.
Ratchet
Adjustment
Wheel
Lockscrew
(Typ)
Figure 5
4 of 5
Tyco Electronics Corporation
Rev A