408-4250 Datasheet, PDF (4/4 Pages) Tyco Electronics – Read these instructions and understand them before using the seating tool.

Seating Tools 318860-[ ]
408-4250
Regular inspections should be performed by quality
control personnel. A record of scheduled inspections
should remain with the tool or be supplied to
supervisory personnel responsible for the tool. The
inspection frequency should be based on the amount
of use, working conditions, operator training and skill,
and established company standards.
6. MAINTENANCE
It is recommended that each operator be made aware
of, and responsible for, the following steps of daily
maintenance:
1. Remove dust, moisture, and other contaminants
with a clean, soft brush, or lint–free cloth. Do NOT
use objects that could damage the tool.
2. Ensure that the screws are in place and
secured.
3. When the tool is not in use, store it in a clean,
dry area.
7. REPLACEMENT AND REPAIR
The parts listed in Figure 2 are customer–
replaceable. A complete inventory should be stocked
and controlled to prevent lost time when replacement
of parts is necessary. Parts other than those listed
should be replaced by Tyco Electronics to ensure
quality and reliability. Order replacement parts
through your representative, or call 1–800–526–5142,
or send a facsimile of your purchase order to
717–986–7605, or write to:
CUSTOMER SERVICE (038–035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105–3608
8. REVISION SUMMARY
Since the previous release of this instruction sheet,
the logo was changed.
4 of 4
Tyco Electronics Corporation
Rev C