408-4109 Datasheet, PDF (4/5 Pages) Tyco Electronics – Pistol Grip Seating Tool

408-4109
NOTE
i
When seating unshrouded pin connectors, it is
necessary to maintain pressure against the contact
housing until the pins enter the clearance slot. See
Figure 5.
CAUTION
Damaged product should not be used. If a
damaged product is evident, it should be removed
!
and replaced with a new one.
Pins Positioned in
Clearabnce Slot
Drive Bar (Ref)
Maintain Pressure
Against Housing Until
Pins Enter Clearance
Slot
Seating tool (Ref)
Guide
Figure 5
4. Inspect connector using the inspection criteria in
Application Specification 114-25026.
5. Remove connector from tool.
NOTE
i
Contacts are properly seated when the locking
lances are seated against the housing window. See
Figure 6.
Locking Lances Seated Against
Housing Window
Carrier
Strip
Carrier Strip
Removed
From Connector
5. TOOL INSPECTION
The procedures that follow have been established to
ensure the quality and reliability of seating tools. A
brief inspection should be made daily, and a more
detailed inspection should be scheduled regularly by
your Quality Control personnel.
5.1. User Maintenance
Each user should be made aware of, and responsible
for, the following:
1. Remove dust, moisture, and contaminants using
a clean brush or a soft, lint-free cloth. Do not use
objects that could damage the seating tool.
2. Make sure all components are in place and
properly secured. If not, return the seating tool to
your supervisor.
3. Squeeze and release the cam handle to be sure
the mechanism inside the body moves freely and
does not bind.
5.2. Quality Control Maintenance
Regular inspections should be performed by your
Quality Control personnel, and a record of quality
control inspections should remain with the personnel
responsible for the tool.
We recommend one inspection a month; however,
operator training and skill, amount of use, ambient
working conditions, and your company's standards are
all factors to consider when establishing inspection
frequency.
These inspections should be performed in the
following sequence:
1. Remove any accumulated film with a suitable
cleaning agent that will not affect paint or
polycarbonate plastic.
2. Make sure all components are in place and are
tightly secured.
3. Make a few test seatings and inspect the results
using the inspection criteria in Application
Specification 114-25026.
Figure 6
6. Manually bend carrier strip up and down until it
breaks off.
6. REPAIR
A complete inventory of customer-replaceable parts
for the seating head tool should be stocked and
controlled to prevent lost time when replacement of
parts is necessary. See Figure 7. Order replacement
parts through your Tyco Electronics Representative, or
call 1-800-526-5142, or send a facsimile of your
purchase order to 1-717-986-7605, or write to:
Rev C
4 of 5