2-1393813-6 Datasheet, PDF (4/7 Pages) Tyco Electronics – Cradle S Relay V23054/V23062

Dimensions
V23062-Axxx, size I type
Signal Relays
Cradle S Relay V23054/V23062 (Continued)
V23062-Bxxx, size II type
AXICOM
Instructions for Impulse Operation
The maximum voltage stated in the part code table can be increased for
impulse operation as follows:
U_{II Impuls}
U_{II tamb}xq
U_{II tamb} Maximum continuous voltage at ambient temperature t_amb
q
Factor
The impulse voltage must not exceed 80% of the test voltage (winding/
frame or winding/winding) or 2.5 times the value of the maximum voltage
listed in the part code table.
Ift_ED ≤ 3s then q=
; Ift_ED = Pulse width, t₂ = Cycle time. If t_ED > 3s the
value of q must be obtained from the nomograph.
Examples of various periodic pulse trains (energizing side)
1. Periodic recurrence of one energizing pulse
2. Periodic recurrence of two unequal energizing pulses
tED = tI + tII
tI + tII = Pulse widths
within one cycle
4
03-2012, Rev. 0312
www.te.com
© 2011 Tyco Electronics Corporation,
a TE Connectivity Ltd. company
Datasheets and product specification
according to IEC 61810-1 and to be used
only together with the ‘Definitions’ section.
Datasheets and product data is subject to the
terms of the disclaimer and all chapters of
the ‘Definitions’ section, available at
http://relays.te.com/definitions
Datasheets, product data, ‘Definitions’ sec-
tion, application notes and all specifications
are subject to change.