408-8908 Datasheet, PDF (3/6 Pages) Tyco Electronics – Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools.

Strip Length
Hydraulic Head (Typical)
Die Set
408-8908
Wire Barrel
Terminal
Crimped Flag
Terminal
PRODUCT
696775-1
696779-1
322727-[ ]
321576
321060
321064
321066
321584
327887
321529-[ ]
NOMINAL WIRE SIZE
MM²
AWG
7-8
8
13 - 15
6
21
4
34 - 35
2
59 - 60
1/0
67 - 70
2/0
80 - 95
3/0
100 - 125
4/0
Figure 3
NOTE
i
If terminal sticks in die after crimping, grasp wire
close to crimp and apply a rocking motion to
remove the die.
STRIP LENGTH
MINIMUM
MAXIMUM
9.53 [.375]
11.18 [.440]
12.70 [.500]
13.82 [.554]
17.06 [.672]
22.23 [.875]
23.81 [.937]
26.98 [1.062]
28.58 [1.125]
14.27 [.562]
15.48 [.609]
18.65 [.734]
23.81 [.937]
25.40 [1.000]
28.58 [1.125]
30.16 [1.187]
Hydraulic Head
(Typical)
6. Refer to Paragraph 5.1, Crimp Inspection, for
terminal crimp inspection procedure.
5. MAINTENANCE AND INSPECTION
DANGER
Disconnect power supply before performing
maintenance, adjustments, inspections, and
STOP
repairs.
5.1. Crimp Inspection (Figure 5)
Inspect crimped terminals by checking the features
described in Figure 5. Use only terminals that meet the
conditions shown in the ACCEPT column. Terminals
displaying the features shown in the REJECT column
can be avoided by careful use of these instructions
and by performing the maintenance and inspection
procedures described in Paragraphs 5.2 and 5.3.
Center Terminal
Wire Barrel in Nest
Hold Flag Terminal
Tongue Against
Slope on Nest Until
Crimp is Started
Figure 4
Rev A
3 of 6