|
408-8717 Datasheet, PDF (3/3 Pages) Tyco Electronics – Hydraulic Hand Crimping Tool | |||
|
◁ |
Hydraulic Hand Crimping Tool 1490749-1
408-8717
5. Check the clearance between bottoming
surfaces of crimping dies. If clearance is 0.025 mm
[.001 in.] or less, the crimp pressure is satisfactory.
If clearance exceeds 0.025 mm [.001 in.], the
crimp pressure is not considered satisfactory. See
Section 6, RETURN/REPLACEMENT.
If the tool conforms to these inspection procedures,
lubricate it with a THIN coat of any good grade
SAE 20 motor oil and return it to service.
or send a facsimile of your purchase order to
1â717â986â7605, or write to:
CUSTOMER SERVICE (38â35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105â3608
Crimping heads may also be returned for evaluation
and repair. For tool repair service, contact a Tyco
Electronics Representative at 1â800â526â5136.
6. RETURN/REPLACEMENT
Order replacement parts through your Tyco
Electronics Representative, or call 1â800â526â5142,
7. REVISION SUMMARY
S Updated document to corporate requirements
S New format
150 mm
[5.9 In.]
(Closed)
Weight: 7.8 kg (17.2 lb)
640 mm
[25.2 In.]
Figure 3
Rev A
Tyco Electronics Corporation
3 of 3
|