408-8394 Datasheet, PDF (3/3 Pages) Tyco Electronics – Reasons for reissue of this instruction sheet are provided in Section 7, REVISION SUMMARY.

Seating Tools 1338742- [ ] and 1338743- [ ]
Seating Tools 1338742- [ ]
A
B
C
Seating Tools 1338743- [ ]
A
B
408- 8394
C
SEATING TOOL
1338742-- 1
1338742-- 2
1338742-- 3
1338743-- 1
1338743-- 2
1338743-- 3
A
24.89 [.980]
DIMENSION
B
28.45 [1.12]
49.78 [1.96]
28.45 [1.12]
248.92 [9.80]
24.89 [.980]
49.78 [1.96]
248.92 [9.80]
28.45 [1.12]
35.05 [1.38]
35.05 [1.38]
35.05 [1.38]
Figure 3
C
27.94 [1.10]
27.94 [1.10]
27.94 [1.10]
21.08 [.83]
21.08 [.83]
21.08 [.83]
CAUTION
!
A damage connector should not be used. If a
damaged connector is evident, it should be
removed from the pc board and replaced with a
new one.
should remain with the tool or be supplied to
supervisory personnel responsible for the tool. The
inspection frequency should be based on the amount
of use, working conditions, operator training and skill,
and established company standards.
5. MAINTENANCE AND INSPECTION
5.1. Initial Inspection
It is recommended that the seating tool be inspected
using Figure 3 immediately upon arrival in your facility
to ensure that it has not been damaged during
shipment.
5.2. Daily Maintenance
It is recommended that each operator be made aware
of, and responsible for, the following steps of daily
maintenance:
1. Remove dust, moisture, and other contaminants
with a clean, soft brush, or lint--free cloth. Do NOT
use objects that could damage the tool or any of its
components.
2. Ensure that the screws are in place and
secured.
3. When the tool is not in use, store it in a clean,
dry area.
5.3. Periodic Inspection
Regular inspections should be performed by quality
control personnel. A record of scheduled inspections
6. REPLACEMENT
The seating tool is not repairable. Order replacement
seating tools through your representative, or call
1- 800- 526- 5142, or send a facsimile of your
purchase order to 1- 717- 986- 7605 or write to:
CUSTOMER SERVICE (38--35)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105--3608
7. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated instruction sheet to corporate
requirements
S Removed references to support anvil
S Changed Paragraph 3.2
S Modified Step 7, added CAUTION, and added
NOTE to Section 4
S Removed phone number for customer repair
service
Rev B
Tyco Electronics Corporation
3 of 3