408-10047 Datasheet, PDF (3/5 Pages) Tyco Electronics – Reasons for reissue of this instruction sheet are provided in Section 8, REVISION SUMMARY.

Seating Tool Assemblies 1804872-[ ], 1901220-[ ], and 1901221-[ ]
408-10047
Note: Not to Scale
Ram of Application Tool
(Fully Down)
Application Tool
A
Shut Height
(Ram Fully Down)
B
(See Section 4)
Insertion Tool Bottomed on
Floor of Header Assembly
Compliant Pin Contacts (and
Hold-Down Clips) Inserted into
Holes in PC Board and PC
Board Support Fixture
Header Assembly
PC Board
PC Board
Support Fixture
DIMENSION A
Seating Height (Header Assembly Seated)
34.93+0.13 mm [1.375+.005 in.]
Figure 2
DIMENSION B
Maximum Gap Allowed
0.10 mm [.004 in.]
NOTE
i
For detailed application requirements of the
header assembly, refer to Application
Specification 114-13038.
3. Check that the inserts are tight against each
other. If not, loosen the socket set screws, adjust
the inserts, then tighten the socket set screws.
6. MAINTENANCE AND INSPECTION
6.1. Daily Maintenance
It is recommended that each operator be made aware
of, and responsible for, the following steps of daily
maintenance:
1. Remove dust, moisture, and contaminants with
a clean, soft brush or a lint–free cloth. DO NOT
use objects that could damage the seating tool
components.
2. When the seating tool is not in use, store it in a
clean, dry area.
6.2. Periodic Inspection
1. Regular inspections should be performed by
quality control personnel. A record of scheduled
inspections should remain with the seating tool or
be supplied to personnel responsible for the
seating tool. Inspection frequency should be based
on amount of use, working conditions, operator
training and skill, and established standards.
2. Check that the socket set screws are in place
and tight.
7. REPLACEMENT AND REPAIR
Customer–replaceable parts are listed in Figure 3.
A complete inventory should be stocked and
controlled to prevent lost time when replacement of
parts is necessary. Parts other than those listed
should be replaced by Tyco Electronics to ensure
quality and reliability. Order replacement parts
through your representative, or call 1–800–526–5142,
or send a facsimile of your purchase order to
717–986–7605, or write to:
CUSTOMER SERVICE (038–035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105–3608
For customer repair service, call 1–800–526–5136.
8. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated document to corporate requirements
S Added Seating Tool Assembly 2–1804872–8
Rev E
Tyco Electronics Corporation
3 of 5