V23700-C0001-A408 Datasheet, PDF (2/4 Pages) Tyco Electronics – Automotive Relays, High Voltage Precharge Relays

Terminal Assignment
1 form X (NO DM)
PCB version
Dimensions
PCB version
Automotive Relays
High Voltage Precharge Relays
Mini K HV (Continued)
Terminal Assignment
1 form X (NO DM) with resistor
Plug-in version
+
-
Dimensions
Plug-in version
View of the Terminals (bottom view)
View of the Terminals (bottom view)
Detail PCB version: minimum clearance requirements (see note below)
2
11-2012, Rev. 1112
www.te.com
© 2012 Tyco Electronics Corporation,
a TE Connectivity Ltd. company.
Notes regarding PCB-layout and terminal assignment:
Pin 4 must not be electrically connected, no solder eye at that pin is allowed, only a drill-hole without via
Potential assignment of pins:
- pins 1; 2: low voltage (LV)
- pins 5; 7; 4(*): high voltage (HV)
- pin 8a; 8b: no potential but internally connected
(*) pin 4 is on HV potential in ON-state of relay only.
Notes regarding clearance and creepage distances:
The required clearance and creepage distances between HV and LV potential must be ensured.
Layout of the PCB has to ensure min. clearance and creepage distances of conducting relay parts and relay terminal 1 and
conducting relay parts and terminal 2 respectively. Refer to detail drawing.
Minimum distance to neighboring ferruginous parts: 3mm.
Datasheets and product specification ac-
cording to IEC 61810-1 and to be used only
together with the ‘Definitions’ section.
Datasheets and product data is subject to the
terms of the disclaimer and all chapters of
the ‘Definitions’ section, available at
http://relays.te.com/definitions
Datasheets, product data, ‘Definitions’ sec-
tion, application notes and all specifications
are subject to change.