MA02206GJ_1 Datasheet, PDF (2/6 Pages) Tyco Electronics – 3.6 V, 0.5 W, RF Power Amplifier IC for DECT, 1800 - 2000 MHz

3.6 V, 0.5 W, RF Power Amplifier IC for DECT,
1800 - 2000 MHz
MA02206GJ
V4
Electrical Specifications: V_DD = +3.6 V, PIN = -2 dBm, Duty Cycle = 100%, T_S = 37°C³,
measured on evaluation board shown herein.
Parameter
Frequency
Output Power
Power Added Efficiency
Drain Current
2nd Harmonics
3rd Harmonics
Input VSWR
Off Isolation
Thermal Resistance
Load Mismatch
Stability
Test Conditions
—
1900 MHz
1900 MHz
1900 MHz
—
—
—
VDD = 0V
Junction to soldering point (T_S)³
V_DD = 4.5 V, VSWR = 5:1, P_IN = -2 dBm
PIN = -2 to +2 dBm, V_DD = 0 - 5.0 V, Load VSWR = 5:1,
all phases
Units Min. Typ. Max.
MHz
1880
1900
1930
dBm
25
26.9
28
%
—
57
—
mA
—
228
330
dBc
—
-37
-30
dBc
—
-38
-34
Ratio
—
1.3:1
2.0:1
dB
—
44
—
°C/W
—
25
—
No Degradation in Power Output
All non-harmonically related outputs more
than 60 dB below desired signal
3. T_S is the temperature measured at the soldering point of the downset paddle on the bottom of the IC.
4. Output power and efficiency have been optimized for input drive levels between –2 and +2 dBm. Stability is only specified within this
range. For operation outside of this range, contact the factory.
MSOP-8-EP
2
M/A-COM Inc. and its affiliates reserve the right to make changes to the
product(s) or information contained herein without notice. M/A-COM makes
no warranty, representation or guarantee regarding the suitability of its
products for any particular purpose, nor does M/A-COM assume any liability
whatsoever arising out of the use or application of any product(s) or
information.
• North America Tel: [phone] / Fax: [phone]
• Europe Tel: [phone] / Fax: [phone]
• Asia/Pacific Tel: [phone] / Fax: [phone]
Visit www.macom.com for additional data sheets and product information.