408-9745 Datasheet, PDF (2/2 Pages) Tyco Electronics – Reasons for reissue of this instruction sheet are provided in Section 5, REVISION SUMMARY.

MTA Terminating Head Repair Kits 856600-[ ]
408-9745
3. Remove the feed slide (subassembly) from the
housing.
CAUTION
!
The feed slide (subassembly) is spring-loaded.
Handle the subassembly carefully to avoid
inadvertent disassembly.
4. Using the drill blank, drive the roll pin past the
feed pawl. Remove and discard the old feed pawl.
5. Install the new feed pawl.
NOTE
i
BE SURE that the compression spring under the
locating pawl is properly located.
4. REPLACEMENT AND REPAIR
The repair kit should be stocked to prevent lost time
when replacement of parts is necessary. Order
replacement parts through your representative, or call
1–800–526–5142, or send a facsimile of your
purchase order to 717–986–7605, or write to:
CUSTOMER SERVICE (038–035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105–3608
Terminating heads may be submitted for evaluation
and repair. For customer repair service, call
1–800–526–5136.
6. Install the new feed slide (subassembly).
7. Rotate and depress the adjuster slightly to
remove the cam. Inspect the condition of the
inserter. If the inserter is damaged or broken, it
must be replaced according to Section 4. The
inserter is not normally a wearing part and is not
contained in the repair kit.
8. Install the new cam, and rotate the adjuster.
Make sure that the cam and the inserter are
oriented as shown in Figure 2.
9. Install the housing into the terminating head as
follows:
a. Depress the adjuster slightly.
b. Guide the inserter into the slot in the housing.
c. Engage the feed slide into the opening in the
cam.
d. Place the housing on the terminating head
and secure it with the four hex head screws.
5. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated document to corporate requirements
S Added text to Section 2
S Corrected terminology in Steps 4 and 5 of
Section 3
2 of 2
Tyco Electronics Corporation
Rev B