408-8339 Datasheet, PDF (2/2 Pages) Tyco Electronics – 90-Degree Cable Clamp Assembly

408-8339
1. Turn off the machine electrical functions by
switching the rocker switch on the back of the
machine control module.
DANGER
STOP
To avoid personal injury, DISCONNECT air and
electric power before making adjustments to the
machine or cable clamp. DO NOT make
adjustments while the machine is operational.
2. Remove the machine main cover of the
machine.
3. Slide the bottom of the cable clamp onto the
base block assembly track as shown in Figure 2.
Locking Screw
Cable
Clamp
Base Block
Assembly Track
Base Block
Assembly
Figure 2
4. On the machine, plug the air hose from the
clamp solenoid valve (see Figure 3) onto the
fitting of the cable clamp (refer to Figure 1).
5. Turn on the air to the machine, and inspect
the cable clamp for air leaks.
Air Hose
Clamp
Solenoid Valve
6. Load a properly prepared cable into the cable
clamp.
7. The cable outer jacket must be removed prior
to placing the cable in the cable clamp.
8. Adjust the position of the cable clamp and
cable so that the cable breakout is located
behind the first pair of connector contacts.
9. Tighten the locking screw with a ⁵/₃₂-in. hex
wrench.
10. Replace the main cover of the machine, and
turn on the machine electrical power.
4. MAINTENANCE
Lubricate the position adjustment track with a good,
quality, light machine oil to ensure optimum service.
Wipe off any excess oil.
5. REPLACEMENT PARTS
Figure 4 lists recommended customer-replaceable
parts. These parts should be inspected regularly.
Customer-replaceable parts should be stocked to
prevent machine or assembly downtime in the event
that they require replacement. For location of the
parts, refer to Figure 1. For location of the air hose
and clamp solenoid valve, refer to Figure 3.
PART
NUMBER
763596-1
980311-3
980451-1
980338-1
994916-1
DESCRIPTION
Wire Holder
Air-Activated Cylinder
Spring Plunger
Air Hose
Clamp Solenoid Valve
QTY PER
ASSEMBLY
1
1
1
Ref
1
Figure 4
Order replacement parts through your representative,
or call 1-800-526-5142, or send a facsimile of your
purchase order to 1-717-986-7605, or write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
6. REVISION SUMMARY
Revisions to this instruction sheet include:
• Updated instruction sheet to corporate
requirements
Rev B
Figure 3
2 of 2