MLO80100 Datasheet, PDF (1/2 Pages) Tyco Electronics – Surface Mount Voltage Controlled Oscillator EGSM 920 - 960 MHz

Surface Mount Voltage Controlled Oscillator
EGSM 920 - 960 MHz
MLO80100-00940
V2.00
Features
q _{Miniature Size}
q _{Surface Mount Package}
q _{Electrically Shielded}
q _{Low Phase Noise}
q _{Highly Linear Tuning}
Description
LSM1 Package
4.0
0.8
IDENT
12.7
11.8
VCC
M/A-COM
VT
PART NO.
DATE
RF
The MLO80100-00940 is a fundamental single ended oscillator
designed for use in cost sensitive wireless and telemetry
applications. The device has been optimised by careful
selection of the bipolar transistor and varactor diode for low
phase noise and high linearity tuning characteristics.
1.6
1.7
0.8
5.5 ₄ ^{DETAIL A.}
The low profile surface mount package used provides for
electrical shielding, ease of assembly and repeatable
performance. M/A-COM’s surface mount manufacturing
techniques together with automatic assembly and electrical
testing ensure a high degree of electrical and mechanical
repeatability at low cost and in high volume. Manufacturing is
carried out in an ISO 9000 qualified facility.
3
DETAIL A.
Electrical Specifications¹, T_A = +25°C, V_CC = +5 V (unless otherwise stated)
1
2
8.0
SOLDER RESIST
Parameter
Frequency Range
Tuning Voltage (V_T)²
RF Output Power³
Supply Voltage (V_CC)⁴
Supply Current (I_CC)
Phase Noise⁵
Tuning Sensitivity
Tuning Linearity
Modulation Bandwidth
Harmonic Outputs⁶
Frequency Pushing
Frequency Pulling
Frequency Drift
Tune Input Capacitance
Test Conditions
920 - 960 MHz
SSB at 100 KHz offset from carrier
920 - 960 MHz
920 - 960 MHz
3 dB bandwidth
V_CC 4.75V to 5.25V
1.5:1 VSWR load, all phases
Units
MHz
V
dBm
V
mA
dBc/Hz
MHz/V
Ratio
MHz
dBc
MHz/V
MHz
MHz/°C
pF
Min
920
+0.5
-2.0
+4.75
2.0
Typ
+5.00
-128
15
1.2
0.06
Max
960
+4.5
+2.0
+5.25
15
-125
1.7
-15
2.0
2.0
50
1. All specifications apply with a 50 ohm load impedance.
2. Tuning voltages shown are the minimum and maximum voltages
required to tune the frequency range including temperature effects
-20°C to +70°C. Devices will oscillate normally with tuning voltages
from 0V to +10V.
3. Output power window includes unit to unit variation, temperature
effects -20°C to +70°C and frequency flatness (typically ±0.5 dB at
anyconstant temperature).
4. Devices may be operated at lower supply voltage with reduced per-
formance.
5. For typical phase noise at other offsets see phase noise curve.
6. No non-harmonic spurious visible when measured on a test system
with a dynamic range of 70 dB.
Specifications Subject to Change Without Notice.
M/A-COM Ltd.
North America: Tel. [phone]
Fax [phone]
s Asia/Pacific: Tel. [phone]
Fax [phone]
1
s Europe: Tel. [phone]
Fax [phone]