MA02206GJ Datasheet, PDF (1/6 Pages) Tyco Electronics – 3.6V 0.5W RF Power Amplifier IC for DECT

3.6V 0.5W RF Power Amplifier IC
for DECT
MA02206GJ
FEATURES
•= Single Positive Supply
•= 57% Power Added Efficiency
•= Operation down to 1.2 V
•= 100% Duty Cycle
•= 1800 to 2000 MHz Operation
•= 8 Pin Full Downset MSOP Plastic Package
•= Accommodates Battery Charging Conditions up to
5.6 Volts
•= Self-Aligned MSAG^®-Lite MESFET Process
8 Lead MSOP Package
Package bottom is electrical and thermal ground
DESCRIPTION
The MA02206GJ is a DECT Power amplifier
based on M/A-COM’s Self-Aligned MSAG
MESFET Process. This product is designed
for use in 3.6 V DECT handsets and base
stations.
MAXIMUM RATINGS (Beyond these limits, the device may be damaged or device
reliability reduced. Functional operation at absolute–maximum–rated conditions is not implied.)
Rating
Symbol Value
Unit
DC Supply Voltage
V_DD
6.0
V
RF Input Power
P_IN
10
mW
Junction Temperature
T_J
150
°C
Storage Temperature Range T_STG ^{-40 to +150}
°C
Operating Temperature
T_OPER ^{-40 to +100}
°C
Range
Moisture Sensitivity
JEDEC Level 1
ELECTRICAL CHARACTERISTICS VDD= +3.6 V, PIN= -2 dBm, Duty Cycle = 100 %, TS = 37 °C (Note 1), measured on evaluation
board shown in Figure 9.
Characteristic
Symbol
Min
Typ
Max
Unit
Frequency Range
ƒ
1880
1900
1930 MHz
Output Power (1900 MHz)
Power Added Efficiency (1900 MHz)
P_OUT
η
25.9
52
26.9
57
27.9 dBm
%
Drain Current (1900MHz)
Harmonics
Input VSWR
I_DD
228
330
mA
2ƒ_o
-37
-30
dBc
3ƒ_o
-38
-34
—
1.3:1
2.0:1
—
Off Isolation (VDD=0 V)
—
38
44
dB
Thermal Resistance, Junction to soldering point (T_s) (Note 1)
—
25
°C/W
Load Mismatch (VDD = 4.5 V, VSWR = 5:1, PIN = -2 dBm)
—
No Degradation in Power Output
Stability (PIN = -2 to 2 dBm, VDD = 0-5.0 V, Load VSWR = 5:1, all phases)
—
All non-harmonically related outputs more than
60 dB below desired signal
Note 1: T_s is the temperature measured at the soldering point of the downset paddle on the bottom of the IC.
Note 2: Output power and efficiency have been optimized for input drive levels between –2 to +2 dBm. Stability is only specified within this range. For
operation outside of this range, contact the factory.
Specifications subject to change without notice.
North America: Tel. [phone], Fax [phone]
Asia/Pacific: Tel. [phone], Fax [phone]
Europe: Tel. [phone], Fax [phone]
Visit www.macom.com for additional data sheets and product information
902407 E