DS58-0001 Datasheet, PDF (1/2 Pages) Tyco Electronics – Low Cost Eight-Way GMIC SMT Power Divider 824 - 960 MHz

Low Cost Five-Way GMIC SMT Power Divider
DS58-0001
DS58-0001
Preliminary Specifications
Low Cost Eight-Way GMIC SMT Power Divider
824 - 960 MHz
Features
• Small Size, Low Profile
• Superior Repeatability ( Lot-to-Lot Varation)
• Industry Standard QSOP-20 SMT Plastic Package
• Typical Isolation: 30 dB
• Typical Insertion Loss: 1.5 dB
• Low Cost
• 1 Watt Power Handling
Description
M/A-COM’s DS58-0001 is an IC-based monolithic power divider
in low cost QSOP-20 Plastic Packages. This 8-way power divider
is ideally suited for applications where PCB real estate is at a
premium and part count reduction and cost are critical. Typical
applications include base station switching networks and other
cellular equipment, including subscriber units. Available in tape
and reel.
The DS58-0001 is fabricated using a passive-integrated circuit
process. The process features full-chip passivation for increased
performance and reliability.
SSOP-20
SSOP-20, .150 WIDE
-B-
.010(0.25) M B M
PIN 20
ORIENTATION
MARK (OPTIONAL)
PIN 1
-A-
.3370/.3440
(8.56/8.74)
.025(0.64) BSC.
16X .008/.012
(0.20/0.30)
.150/.157
(3.81/3.99)
.228/.244
(5.79/6.20)
.0530/.0690
(1.35/1.75)
.010/.029 x 45°
CHAMFER
(0.25/0.75)
-C- ^0°-8°
.016/.050
.0040/.0100 (0.40/1.27)
(0.10/0.25)
R .008/.013
(0.20/0.33)
.0070/.010
(0.18/0.25)
.007(0.18) M C A S B M
20-Lead SSOP outline dimensions
(All dimensions per JEDEC No. MS-137-AD, Issue C)
Dimensions in () are in mm.
Unless Otherwise Noted:.XXX= ±.010 (.XX= ±0.25)
.XX= .02 (.X= ±0.5)
Ordering Information
Part Number
Package
DS58-0001
DS58-0001-TR
DS58-0001-RTR
QSOP 20-Lead Plastic Package
Forward Tape and Reel¹
Reverse Tape and Reel¹
1. If specific reel size is required, consult factory for part number
assignment.
Typical Electrical Specifications¹, T_A= +25°C
Parameters
Insertion Loss Above 9.0 dB
Isolation
VSWR
Units
dB
dB
—
Min.
—
20
—
Amplitude Balance
dB
—
Phase Balance
°
—
1. All specifications apply with a 50-ohm source and load impedance.
Typ.
1.5
30
1.7:1
0.4
5
Max.
2.0
—
2.0:1
0.8
10
M/A-COM Division of AMP Incorporated s North America: Tel. [phone], Fax [phone] s Asia/Pacific: Tel.[phone], Fax [phone]
s Europe: Tel. [phone], Fax[phone]
www.macom.com
AMP and Connecting at a Higher Level are trademarks.
The preliminary specifications data sheet contains typical electrical specifications which may change prior to final introduction.
V1.A