DPL12 Datasheet, PDF (1/3 Pages) Tyco Electronics – 12mm Rotary Encoder with LED

12mm Rotary Encoder with LED
Type DPL12 Series
Type DPL12 Series
12mm Rotary incremental encoder with
LED for use in electronic equipment.
Can be supplied with or without switch
with customisation to standard options.
Characteristics -
Electrical
Pulses:
Contact Rating:
Dielectric Strength:
Insulation Resistance (min):
Operating Speed (RPM):
Switch Power Rating (where fitted):
Switch Contact Resistance:
Electrical Travel:
Rotational Noise:
Chattering:
24
0.5mA 5VDC
300VAC / 1mA, 1 minute
100M ohms at 250VAC
60 RPM
16VDC 3A
100m ohm Max
Continuous
t2 = 2.0 ms max (see below)
t1 & t3 = 3.0 ms max (see below)
Key Features
■ 12mm Rotary Encoder
■ Incremental Type
■ Push on Switch Option
■ Various Shaft Lengths
■ LED Colour Options
■ Detent Options
Code Off area V = 3.5V or more. Code on area V=1.5V or less
LED
Switch – Dual colour – see below for characteristics
No Switch Single colour– see below for characteristics
Colour options
No Switch – Red, Green, Blue
Switch – 1: Blue/Green, 2: Blue/Orange, 3: Green/Red
Characteristics -
Mechanical
Total Mechanical Travel:
Detents:
Switch Operating Force:
Switch Travel:
Shaft Type:
Shaft Length (from Mounting Surface):
Continuous
0, 24
400+/- 200gf
0.5mm
F – Flatted, K - Knurled
See Chart below
Characteristics -
Environmental
Operating Temperature
Rotational Life
-40 - +85 degrees C
30,000 Cycles
Output Signal Format
Shaft Rotational
Direction
Signal
Format
Clockwise
A (Terminal A-C)
B (Terminal B-C)
Anticlockwise
A (Terminal A-C)
B (Terminal B-C)
Literature No. 1-1773449-0 Dimensions are shown for
Issued: 02-08
reference purposes only.
Dimensions are in
millimetres unless
otherwise specified.
Specifications subject to
change.
tycoelectronics.com
passives.tycoelectronics.com