AM-AMC-140 Datasheet, PDF (1/3 Pages) Tyco Electronics – High Performance Amplifier, 29 dB Gain, 10 - 200 MHz

High Performance Amplifier,
29 dB Gain, 10 - 200 MHz
V 5.00
Features
n +47 dBm Typical Midband Third Order Intercept
n +28 dBm Typical Midband 1 dB Compression
n 5.4 dB Typical Midband Noise Figure
Description
M/A-COM’s AM-140 is a coupler feedback amplifier with
high intercept and compression points. The use of coupler
feedback minimizes noise figure and current in a high
intercept amplifier. This amplifier is packaged in a flatpack
with flanges. Due to the internal power dissipation the
thermal rise should be minimized. The ground plane on the
PC board should be configured to remove heat from under
the package. AM-140 is ideally suited for use where a high
intercept, high reliability amplifier is required.
FP-9
C-25
Absolute Maximum Ratings ¹
Parameter
Absolute Maximum
Max. Input Power
+15 dBm
V_bias
+17.0 V
Operating Temperature
Storage Temperature
-55°C to +85°C
-65°C to +125°C
1. Operation of this device above any one of these
parameters may cause permanent damange.
Pin Configuration
Pin #
1
2
3
4
5
Function
RF OUT
GND
GND
GND
Vbias²
Pin #
6
7
8
9
10
Function
RF IN
GND
GND
GND
Vbias²
2. Bias may be applied to either a single bias pin, or both
bias pins. If bias is applied to both bias pins, it is impor-
tant that potential ground loops be avoided, and that
there is adequate filtering on the bias lines.