68010 Datasheet, PDF (1/9 Pages) Tyco Electronics – Crimping Die Assemblies for COPALUM Sealed Terminals and Splices

Crimping Die Assemblies for
COPALUM* Sealed Terminals and Splices
Instruction Sheet
408-2281
21 NOV 08 Rev W
Nest
(Stationary Die)
Alignment
Dot
2. DESCRIPTION (Figure 1)
The die assemblies consist of stationary dies (nests)
and moving dies (anvils). Refer to Figure 2 to ensure
the compatibility of die assemblies, crimping heads,
and terminals and splices.
2.1. Die Installation
DANGER
To avoid personal injury, ALWAYS DISCONNECT
electrical and air supply to power unit before
installing dies.
Alignment
Dot
Anvil
(Moving Die)
Front
CRIMPING DIE ASSEMBLY
CRIMPING HEAD
068006-00
068008-00
068010-00
0314964-1
068007-0
068009-0
068010-2
68008-1
69066
0058422-1
1752787-1
1752877-1
1976441-1
1976442-1
1976443-1
059877-1
068011-1
314948-1
Figure 1
0058422-1
1752787-1
1. INTRODUCTION
The crimping die assemblies listed in Figure 1 are
used to crimp COPALUM sealed terminals and
splices.
The crimping die assemblies must be installed into
the crimping heads shown in Figure 1. Refer to the
instruction sheet packaged with the crimping head for
information concerning die installation and general
performance of the head.
Reasons for reissue of this instruction sheet are
provided in Section 7, REVISION SUMMARY.
Read these instructions thoroughly before using the
die assemblies.
NOTE
i
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures and
illustrations are for reference only and are not
drawn to scale.
The shanks on the moving and stationary dies are
offset, and there are alignment dots on the FRONT
surface of the dies. The shanks of the dies must be
offset to the same surface and the dots must be
aligned, and face the operator, in order to achieve
proper mating of the dies.
CAUTION
!
DO NOT mix die components from different die
assemblies.
Refer to Instruction Sheet 408–9535 for die
installation procedure for Crimping Head 58422–1;
408–2453 for Crimping Head 69066; 408–8914
for Crimping Head 1752787–1; and 408–8956 for
Crimping Head 1752877–1.
2.2. Wire, Terminal, and Splice Selection (Figure 2)
Refer to Figure 2 and select the appropriate wire, die
assembly, and terminal or splice. Strip the wire to the
length indicated in the table.
CAUTION
DO NOT nick or cut the wire strands.
!
NOTE
i
For aluminum-to-aluminum application, butt
splices will accept the same wire size at either
end. However, for aluminum-to-copper
applications, the size of the copper wire must be
decreased to a smaller size to compensate for
differences in the electrical properties of copper
and aluminum. It is also necessary to use a
smaller wire size when using copper wire in a
terminal. Refer to CMA range listed with each
wire size in Figure 2.
E2008 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 9
LOC B