55PC0241 Datasheet, PDF (1/1 Pages) Tyco Electronics – This specification sheet forms a part of the latest issue of Raychem Specifiction 55PC.

SPECIFICATION CONTROL DRAWING
TITLE
FOUR CONDUCTOR CABLE, UNSHIELDED, UNJACKETED, 600 VOLT
Date
10-22-05
This specification sheet forms a part of the latest issue of Raychem Specifiction 55PC.
COMPONENT WIRES - 55PC0211
55PC0241
Revision
B
PART NUMBER
1/
55PC0241-24-*
55PC0241-22-*
55PC0241-20-*
55PC0241-18-*
55PC0241-16-*
55PC0241-14-*
55PC0241-12-*
55PC0241-10-*
CONSTRUCTION DETAILS
CONDUCTOR
SIZE
(AWG)
24
22
20
18
16
14
12
10
LOWER SPEC
LIMIT
.087
.100
.119
.139
.155
.189
.231
.283
DIAMETER
( in.)
TARGET
VALUE
.102
.117
.139
.163
.182
.221
.270
.331
UPPER SPEC
LIMIT
.117
.134
.159
.188
.209
.253
.309
.379
WEIGHT
( lbs/1000 ft. )
TARGET
VALUE
8.06
11.80
17.83
26.83
34.07
52.44
80.33
126.67
UPPER SPEC
LIMIT
8.38
12.19
18.32
27.56
34.92
53.64
81.99
129.46
CABLE RATINGS AND ADDITIONAL REQUIREMENTS
TEMPERATURE RATING: 150°C
Maximum continuous conductor temperature
VOLTAGE RATING: 600 volts (rms) at sea level
INSULATION FLAWS:
Impulse Dielectric Test, 8.0 kV (peak)
PART NUMBER:
The "*" in the part numbers above shall be replaced by
a color code designator with a slash separating the
component wire colors. Colors shown do not necessarily
reflect the sequence of manufacturing.
1/ Example: AWG 22, black, red, orange and yellow
component wires: 55PC0241-22-0/2/3/4
Users should evaluate the suitability of this product for their application. Specifications are subject to change without notice.
Tyco Electronics also reserves the right to make changes in materials or processing, which do not affect compliance with any specification, without notification to Buyer.
1/ COLORS AND COLOR CODE DESIGNATORS SHALL BE IN ACCORDANCE WITH MIL-STD-681. HOWEVER, DUE TO LENGTH LIMITATIONS OF THE RAYCHEM PART NUMBER,
AN ALTERNATIVE COLOR CODE MAY REPLACE MIL-STD-681 COLOR CODE DESIGNATORS. (EXAMPLE: “901/902...” MAY BE REPLACED BY “Axxx”.) OTHER CODES AND
SUFFIXES MAY BE ADDED TO THE PART NUMBER, AS NECESSARY, TO CAPTURE ANY ADDITIONAL REQUIREMENTS IMPOSED BY THE PURCHASE ORDER.
DIMENSIONS ARE IN INCHES AND, UNLESS OTHERWISE DESIGNATED, ARE NOMINAL
Page 1 of 1
THIS SPECIFICATION SHEET TAKES PRECEDENCE OVER DOCUMENTS REFERENCED HEREIN.
REFERENCED DOCUMENTS SHALL BE OF THE ISSUE IN EFFECT ON DATE OF INVITATION FOR BID.
R Wire & Cable
501 Oakside Avenue
Redwood City, CA 94063-3800
Phone: [phone]
Fax: [phone]
© 2005 Tyco Electronics Corporation. All rights reserved.