411-1097 Datasheet, PDF (1/7 Pages) Tyco Electronics – Cumulative Trauma Disorders can result from the prolonged use ofmanually powered hand tools.

Double Action Hand Crimping Tools
525690 and 525691
Instruction Sheet
411- 1097
27 MAY 10 Rev D
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- use, production operations is available.
Insulation Crimp Adjustment Pins
(Shown in Position 3)
Fixed Jaw
(Crimper)
Ratchet
Color- Coded
Handle
Locator/Insulation
Stop
Movable Jaw
(Anvil)
Part Number
525690
525691
TE Tool
Color Code
Red
Blue
Dot Code
1
2
Wire Size Range
(AWG)
20--18
16--14
Figure 1
1. INTRODUCTION
These tools are members of the CERTI--CRIMP*
Double Action Hand Crimping Tools 525690 and
525691 crimp a wide variety of PIDG* terminals and
splices and PLASTI--GRIP* terminals and splices
onto stranded copper wire sizes 20 through 14 AWG.
hand crimping tool family. The ratchet on these tools
ensures full crimping of the product. Once engaged,
the ratchet will not release until the handles have
been FULLY closed.
See Figure 1. Read these instructions thoroughly
before using the tools.
CAUTION ^{The jaws bottom before the ratchet releases. This}
NOTE
i
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures are
not drawn to scale.
design ensures maximum electrical and tensile
!
performance of the crimp. DO NOT re- adjust the
ratchet.
Reasons for reissue of this instruction sheet are
provided in Section 7, REVISION SUMMARY.
2. DESCRIPTION
Each tool features a fixed jaw (crimper), a movable
jaw (anvil), a locator/insulation stop, and a ratchet
attached to a handle.
The locator/insulation stop positions the product
between the jaws and aids in locating the wire in the
product. When closed, the jaws form a crimping
chamber with two sections: an insulation barrel
section and a wire barrel section. The insulation barrel
section crimps the insulation barrel of the product
onto the wire insulation and, simultaneously, the wire
barrel section crimps the wire barrel of the product
onto the wire conductors.
E2010 Tyco Electronics Corporation, Berwyn, PA
TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other product names, logos, or company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 7
LOC B