English
Language : 

408-9913 Datasheet, PDF (1/3 Pages) Tyco Electronics – Read these instructions thoroughly before using the seating tool.
Seating Tools 90754-[ ]
For Z-PACK* 2mm Hard Metric (HM)
Type B Vertical Male Connector Assembly
Seating Tool
Instruction Sheet
408-9913
21 JUL 08 Rev A
Adapter
Blade
Z-PACK 2mm HM Type B
Vertical Male Connector
Assembly 100141-1 (Ref)
ACTION PIN*
Contact
Printed Circuit (PC)
Board
TOOL
90754-1
90754-2
90754-3
CONNECTOR
SIZE (Number
of Positions)
125
110
095
Figure 1
PC Board Support Fixture
(Customer Designed)
1. INTRODUCTION
Seating Tools 90754–[ ] are used to seat Z–PACK
2mm HM Type B male connector assemblies with
ACTION PIN contacts to allow solderless pc board
installation. Each seating tool is specifically designed
for the number of positions in the connector. Refer to
Figure 1.
Read these instructions thoroughly before using the
seating tool.
NOTE
i
All numerical values in this instruction sheet are
in metric units [with U.S. customary units in
brackets]. Dimensions are in millimeters [and
inches]. Figures are not drawn to scale.
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.
2. DESCRIPTION
Each seating tool consist of an adapter and a blade.
During seating, the blade sits inside the connector
engaging the housing floor and contacts preventing
the contacts from pushing out of the housing. The
adapter presses on the top surface of the connector
when the applicator ram applies force to the seating
tool.
2. REQUIREMENTS
2.1. PC Board Support Fixture
A fixture must be used to provide proper support for
the pc board and alignment of the seating tool to the
contacts and to protect the pc board and and
connector from damage. The pc board support fixture
must be designed for the specific needs according to
Instruction Sheet 408–6927.
E2008 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 3
LOC B