408-9242 Datasheet, PDF (1/4 Pages) Tyco Electronics – Read these and all referenced materials before using the die assemblies.

Crimping Die Assemblies 58237-1 and 58237-2
Instruction Sheet
408-9242
14 MAY 09 Rev B
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended-use, production operations is available.
Die Assembly
58237-1
Insulation
Indenter
Braid Indenter
(Stationary Die)
Insulation
Section
(Ref)
Braid Section
(Ref)
Typical
Shielding
Hardware Kit
(Ref)
Insulation
Anvil
(Moving Die)
Hinge
Tabs
Connector
(Included with Kit)
Hex Crimp
(Ref)
Hex Crimp
(Insulation) (Ref)
Ferrule
(Must be Ordered
Separately)
Round Crimp (Braid)
(Ref)
Outer
Shield
Inner
Shield
{ ^FERRULE
PART NO.
CABLE
DIA RANGE
CRIMPING DIE
ASSEMBLY
2-747580-2
12.19 - 14.27
[.480 - .562]
58237-1
3-747580-1
10.72 - 12.45
[.422 - .490]
58237-2
{ Must be ordered separately from shield kits.
HAND CRIMP
TOOL
543344-1
543344-1
Figure 1
{{ ^DIE
HOLDER
58449-1
PNEUMATIC
APPLICATOR
312522-3
NUMBER OF
CONTACTS
37
58449-1
312522-3
37 and 50
{{ Used with Pneumatic Applicator 312522–3
1. INTRODUCTION
Crimping Die Assemblies 58237–1 and 58237–2 are
designed to crimp ferrules onto AMPLIMITE*
Shielding Hardware Kits shown in Figure 1.
The die assemblies may be used in Hand Crimping
Tool 543344–1 or in Die Holder 58449–1. The die
holder is used in conjunction with Pneumatic
Applicator 312522–3. For die installation and crimping
procedures, refer to Instruction Sheet 408–9315,
packaged with the hand tool, and Customer Manual
409–5843, packaged with the pneumatic tool.
Read these and all referenced materials before using
the die assemblies.
E2009 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 4
LOC B