408-9020 Datasheet, PDF (1/1 Pages) Tyco Electronics – Extraction Tool

Extraction Tool 58113-[ ]
Instruction Sheet
408-9020
29 JUL 10 Rev B
Handle
Tip
Figure 1
1. INTRODUCTION
Extraction Tool 58113-[ ] is used to extract a pin grid
array (PGA) substrate package (device) from a low
insertion force (LIF) PGA socket installed onto a
printed circuit (pc) board. Read these instructions
thoroughly before extracting any devices.
NOTE
i
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures are
not drawn to scale.
2. Remove the extraction tool, then insert the tip
(as previously described) into the opposite side
of the assembly, then gently lift the handle until
that side of the device is raised from the socket.
3. Repeat this process for the remaining sides of
the assembly until the device is released from the
socket.
4. TOOL INSPECTION
Inspect the tool immediately upon arrival and at
regularly scheduled intervals according to Figure 3 to
ensure that the tool is not damaged.
76.2 [.30]
0.51 [.020]
81.3 [3.20]
A
B
C
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.
2. DESCRIPTION
Each tool features a handle and a tip with blades. See
Figure 1.
3. USING THE TOOL (Refer to Figure 2)
CAUTION
Make sure that all power to the system is "OFF"
before using the tool.
!
1. Insert the tip of the extraction tool (with the end
of the handle above the socket) between the
device and socket, then gently lift the handle until
that side of the device is raised from the socket.
Lift Tool Handle
Device
Socket
Tip of Tool
PC Board
Figure 2
TOOL
58113-1
58113-3
58113-4
58113-5
NUMBER
OF BLADES
DIMENSION
A
B Typ
C Typ
05
011.7 [.46]
10
024.4 [.96]
1.52 [.060] 2.54 [.100]
13
32.0 [1.26]
16
39.6 [1.56]
Figure 3
5. REPLACEMENT
The extraction tool cannot be repaired. Order
replacement tools through your representative, or call
1-800-526-5142, or send a facsimile of your purchase
order to 717-986-7605, or write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
6. REVISION SUMMARY
Revisions to this instruction sheet include:
• Updated instruction sheet to corporate
requirements
©2010 Tyco Electronics Corporation, Berwyn, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All Rights Reserved
TE logo and Tyco Electronics are trademarks.
PRODUCT INFORMATION 1-800-522-6752
*Trademark. Other products, logos, and company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 1
LOC B