English
Language : 

408-8915 Datasheet, PDF (1/4 Pages) Tyco Electronics – Hydraulic Crimping Head
Hydraulic Crimping Head
1752788 - 1
Instruction Sheet
408- 8915
17 MAR 10 Rev B
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- use, production operations is available.
Yoke
Removable
Latch Pin
NOTE
i
Dimensions on this sheet are in millimeters [with
inches in brackets]. Figures and illustrations are
for reference only and are not drawn to scale.
Reasons for reissue of this instruction sheet are
provided in Section 8, REVISION SUMMARY.
Piston
(Ram)
Pivot Pin
Cylinder
Male Quick--Disconnect
Coupler
Dust Cap
Figure 1
1. INTRODUCTION
This instruction sheet covers application and
maintenance procedures for Crimping Head
1752788--1 shown in Figure 1. The crimping head
accepts interchangeable die sets for a variety of
heavy--duty terminals and splices for large wire sizes
— within the range of 250 MCM through 600 MCM
(thousand circular mils). Refer to instructions
packaged with specific die sets for compatible
products, wire ranges, strip dimensions, and
application procedures.
The crimping head is designed and recommended
only for use with Foot Hydraulic Pump 1583659--1,
Hand Hydraulic Pump 1583661--1, Electric Hydraulic
Pump 1583660--1 (115 Vac), or 1583660--2 (230 Vac).
Read these instructions, and all applicable
references, before using the crimping head.
2. DESCRIPTION
Main components of the crimping head are: a yoke
which houses the stationary die and retains the
terminal assembly for crimping, a removable latch pin
which allows pivoting of the yoke on the pivot pin
(typically required for splice terminations), a cylinder
which contains the head’s hydraulic chamber, a piston
(ram) which holds and controls the moving die, and a
quick connect/disconnect coupler which mates with
the coupler on the hose to release or supply pressure.
DANGER
To avoid injury when using hydraulic crimping
equipment, observe the following precautions:
-- Do NOT modify the crimping equipment in any
way.
-- Use only dies, terminals, and wire specified for
the head.
-- Do NOT perform repairs other than those
specified in the instructional material supplied
with the equipment.
3. INSTALLATION
Each crimping head is shipped with a coating of
lubricating oil to prevent rust and corrosion. Wipe the
oil off before installing the crimping head on the power
unit. Note that the crimping head is shipped without
oil inside the cylinder. To install crimping head,
proceed as follows:
DANGER
Make sure that hydraulic pressure to the hose is
released and that power supply is disconnected
to electric power unit, if applicable.
1. Remove protective dust caps from both quick
connect/disconnect couplers.
2. Hold hose vertically to prevent oil spillage.
Attach hose to coupling section on head. Thread
properly and tighten securely.
CAUTION
!
Oil flow must be unobstructed between power
unit and crimping head. Make sure that all
couplers are fully mated and tightened.
E2010 Tyco Electronics Corporation, Berwyn, PA
TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products names, logos, or company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 4
LOC B