408-8696 Datasheet, PDF (1/3 Pages) Tyco Electronics – Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools.

Hex Crimp Die Assemblies 9-1478243-0,
9-1478245-0, and 9-1478247-0 (used with
SDE-SA Hand Tool Assembly 9-1478240-0)
Instruction Sheet
408-8696
28 SEP 10 Rev B
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use
and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Stationary Jaw
Nest Die
Anvil Die
Moving Jaw
Typical Die Assembly
Hand Tool Frame
9-1478240-0
Figure 1
1. INTRODUCTION
This instruction sheet covers the use and maintenance
of SDE-SA Crimping Dies 9-1478243-0, 9-1478245-0,
and 9-1478247-0 (previously designed for
GREENPAR connectors) in their various
configurations - denoted by the dash numbers . See
the table in Figure 1.
Also shown is the base hand tool frame, the connector
types and the type of coaxial cable used.
Reason for revision may be found in Section 8,
REVISION SUMMARY.
NOTE
i
All dimensions are in millimeters [with inches in
brackets].
of the connector onto the coaxial cable. Each die is
held in the tool by a single screw.
3. DIE INSTALLATION
1. Close the tool handles until the ratchet
releases and then allow them to open fully.
2. See Figure 1 for normal orientation of the dies.
Insert the dies inside the tool jaws and align the
retaining screw holes.
3. Thread the retaining screws into the holes and
carefully close the tool handles. Tighten the
screws with the appropriate hex wrench.
4. CRIMPING PROCEDURE
Refer to Figure 2.
2. DESCRIPTION
Each die assembly consists of a nest die and an anvil
die. When closed, the dies form two crimping
chambers which crimp the center contact and ferrule
4.1. Center Contact
1. Prepare the connector and the cable according
to the instructions packaged with the connector.
GREENPAR was a trademark of GREENPAR Engineering Limited. Essex, England.
©2010 Tyco Electronics Corporation, Berwyn, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 3
LOC B