408-8695 Datasheet, PDF (1/3 Pages) Tyco Electronics – Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools

Crimping Tool Assembly
9-1478239-0
Instruction Sheet
408-8695
06 OCT 10 Rev B
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use
and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Stationary Jaw
Nest Die
Die Assembly
1583581-1
SDE-SA Hand Tool
Frame 9-1478240-0
Anvil Die
Moving Jaw
Figure 1
1. INTRODUCTION
This instruction sheet covers the use and maintenance
of Hex Crimp Die Assembly 1583581-1 used in SDE-
SA Hand Tool Frame 9-1478239-0. See Figure 1. The
entire assembly is referred to as Crimping Tool
9-1478239-0. The tool crimps various plug connectors
onto coaxial cable. See Figure 1 for a list of the
connector types and cable sizes the die set can crimp.
These dies were originally designed for GREENPAR
connectors.
Reason for revision may be found in Section 8,
REVISION SUMMARY.
NOTE
i
All dimensions are in millimeters [with inches in
brackets]. Figures are drawn for identification only
and are not drawn to scale.
2. DESCRIPTION
See Figure 1.
Each die assembly consists of an nest die and an anvil
die. When closed, the dies form two crimping
chambers which crimp the center contact and ferrule
of the connector onto the coaxial cable. Each die is
held in the tool by a single screw.
3. DIE INSTALLATION
1. Close the tool handles until the ratchet
releases and then allow them to open fully.
2. See Figure 1 for normal orientation of the dies.
Insert the dies inside the tool jaws and align the
retaining screw holes.
©2010 Tyco Electronics Corporation, Berwyn, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 3
LOC B