408-8607 Datasheet, PDF (1/6 Pages) Tyco Electronics – Cumulative Trauma Disorders can result from the prolonged use ofmanually powered hand tools.

PRO- CRIMPER* III Hand Crimping
Tool Assembly 91363- 1
with Die Assembly 91363- 2
Instruction Sheet
408- 8607
03 AUG 09 Rev A
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- use, production operations is available.
Locator
Assembly
(Supplied with
Die Assembly)
Stationary Jaw
Back of Tool
(Wire Side)
Front of Tool
(Locator Side)
Terminal
Support
Die
Assembly
Moving Jaw
Ratchet
Adjustment
Wheel
The PRO- CRIMPER III Hand Crimping Tool is a “Commercial” grade
tool and is designed primarily for field installation, repair, maintenance
work, or prototyping in industrial, commercial, or institutional
applications. Product crimped with this tool will meet the crimp height
requirement for hand tools in the appropriate 114 series specification,
but may not comply with other feature parameters of the specification.
Tyco Electronics offers a variety of tools to satisfy your performance
requirements. For additional information, contact the Tooling Assistance
Center at 1- 800- 722- 1111.
Pivot Pin
PRO- CRIMPER III Hand
Tool Frame 354940- 1
(408- 9930)
Stationary
Handle
Moving Handle
TE Die Assembly Locator Assembly{ Contact Family}
91363--2
58516--1
Mini Power Drawer
Contact
Size
(AWG)
20--18
Wire
Insul Dia
(mm [in.])
1.98 to 2.79
[.078 to .110]
{ Supplied with die assembly. Also available separately.
} Contact the Tooling Assistance Center or Product Information (see below) for specific contact part numbers.
Figure 1
Strip Length
(mm [in.])
3.96 to 4.72
[.156 to .186]
1. INTRODUCTION
PRO--CRIMPER III Hand Crimping Tool
Assembly 91363--1 consists of Die Assembly
91363--2 and PRO--CRIMPER III Hand Tool Frame
354940--1. The die assembly consists of crimping
dies and a locator assembly.
Read these instructions thoroughly before crimping
any contacts.
NOTE
i
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
and illustrations are for identification only and are
not drawn to scale.
A list of revisions can be found in Section 11,
REVISION SUMMARY.
E2009 Tyco Electronics Corporation, Harrisburg, PA TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All International Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 6
LOC B