|
408-8589 Datasheet, PDF (1/3 Pages) Tyco Electronics – Reasons for reissue of this instruction sheet are provided in Section 7, REVISION SUMMARY | |||
|
Crimper
Die
Snap-Lock Die Assembly
1338120-1
Instruction Sheet
408-8589
10 MAR 09 Rev A
Screw
Hole
Nest for
Straight Ferrule
2. Secure the crimper die in the stationary jaw of
the tool frame using the die retaining screw. DO
NOT fully tighten the screw.
3. Slowly cycle the tool, allowing the dies to align
themselves. Then, cycle the tool until the dies are
completely closed.
4. Securely tighten both die retaining screws.
Anvil Die
Screw
Hole
Nest for Straight Portion
of Right-Angle Ferrule
Figure 1
Crimper
Die
Stationary
Jaw
PRO-CRIMPER III
Tool Frame
Die Retaining
Screws
1. INTRODUCTION
SnapâLock Die Assembly 1338120â1 is designed to
be used with PROâCRIMPER* III Hand Crimping Tool
Frame Assembly 354940â1 to crimp the straight
portion of the rightâangle ferrule and straight ferrule
for coaxial snapâlock cable connectors onto coaxial
cable. Refer to Instruction Sheet 408â9930 for
information concerning the tool frame assembly.
Anvil Die
Moveable
Jaw
Figure 2
NOTE
i
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures are
not drawn to scale.
Reasons for reissue of this instruction sheet are
provided in Section 7, REVISION SUMMARY.
2. DESCRIPTION
The die assembly consists of a crimper die and an
anvil die that when closed forms two crimping
chambers. See Figure 1. Each die is secured in the
tool by a single screw (included with tool frame).
3. DIE INSTALLATION (See Figure 2)
1. Install the anvil die in the moveable jaw of the
tool frame. Align the screw hole of the die with the
screw hole of the tool frame, then secure the die
with the die retaining screw. DO NOT fully tighten
the screw.
4. CRIMPING PROCEDURE
Refer to 408â4551 for cable strip length and
assembly information for the connector; for detailed
application requirements, refer to Application
Specification 114â13010.
NOTE
i
The center contact must be crimped onto the
cable separately.
1. Assemble the connector according to 408â4551.
_ 2. Place the ferrule in the appropriate nest of the
anvil die (marked â90 â for rightâangle ferrule and
âstraightâ for straight ferrule) so that the shoulder of
the connector butts against the edge of the die and
the crimp claw is facing outward. See Figure 3.
3. While holding the assembly together, cycle the
tool until the dies have closed enough to hold the
assembly in place.
E2009 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 3
LOC B
|
▷ |