408-8583 Datasheet, PDF (1/1 Pages) Tyco Electronics – 0.8mm AMPMODU* Micro Interconnect

0.8mm AMPMODU* Micro Interconnect
Insertion Tool 1490583- 1
Instruction Sheet
408- 8583
29 DEC 09 Rev B
Tip
Figure 1
1. INTRODUCTION
Insertion Tool 1490583--1 is designed to insert a
0.8mm AMPMODU Micro Interconnect contact into a
housing. Read these instructions thoroughly before
attempting to insert a contact.
Reasons for reissue of this instruction sheet are
provided in Section 5, REVISION SUMMARY.
2. DESCRIPTION
The insertion tool is made of stainless steel and is
similar to a pair of tweezers. See Figure 1. The tool
grips the wire when inserting the contact into the
housing.
Wire Gripped
Directly Behind
Contact
Contact
Push Until Contact
Locking Latch
Snaps into Place
3. USING THE TOOL (Figure 2)
1. Using the tip of the insertion tool, grip the wire
directly behind the contact.
2. Holding the wire and contact securely with the
insertion tool, insert the contact into the
appropriate contact cavity. Continue to push the
contact until the locking latch snaps into place.
Locking
Latch
Contact Cavity
4. TOOL REPLACEMENT
The insertion tool is not repairable and should be
replaced when it is worn or damaged.
Insertion tools can be purchased from:
CUSTOMER SERVICE (38--35)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG, PA 17105--3608
Figure 2
5. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated instruction sheet to corporate
requirements
E2009 Tyco Electronics Corporation, Harrisburg, PA TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All International Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 1
LOC B