English
Language : 

408-8322 Datasheet, PDF (1/15 Pages) Tyco Electronics – Reasons for reissue of this document are provided in Section 10, REVISION SUMMARY.
Heavy Duty Industrial (HD-I)
Side-Feed Type Applicator
Instruction Sheet
408-8322
18 DEC 08 Rev C
Ram Post
Locking Screw
Ram
Front Floating Shear
Stock Drag
Anvil
Base Plate
Drag Release
Lever
Strip Guide
Strip Guide
Adjustment Block
Terminal Support
Front Shear Holder
1. INTRODUCTION
Figure 1
CAUTION
The Heavy Duty Industrial (HD–I) Side–Feed Type
Applicator applies side–feed strip terminals to
pre–stripped wires. Each applicator accepts the strip
form of certain terminals, which are identified on the
applicator parts list and exploded view drawing
(Applicator Log) for each applicator. Some terminals
have two carrier strips, others just one.
!
NOTE
i
Denotes a condition which may result in product
or equipment damage.
Highlights special or important information.
These instructions, the parts lists and exploded view
drawings packaged with the machine, and the
appropriate machine manual (409–5128 for the Basic
AMP–O–LECTRIC* Machine; 409–5207 or 409–5289
for the Model “T” Terminating Unit; or 409–5842 for
the Model “G” Terminating Machine), provide all the
information required to operate and maintain the
applicator and machine (or unit).
When reading this document, pay particular attention
to DANGER, CAUTION, NOTE, statements.
DANGER
Denotes an imminent hazard which may result in
moderate or severe injury.
NOTE
i
Dimensions in this document are in metric units.
Reasons for reissue of this document are provided in
Section 10, REVISION SUMMARY.
2. APPLICATOR DESCRIPTION
This applicator is similar in design and function to the
Heavy Duty Miniature Quick–Change Type applicator.
The strip guide area has been re–designed and the
applicator uses metric hardware.
E2008 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 15
LOC B