408-8053 Datasheet, PDF (1/3 Pages) Tyco Electronics – Reasons for reissue of this instruction sheet are provided in Section 4, REVISION SUMMARY.

Miniature (Mini) Quick-Change Applicators
Instruction Sheet
408-8053
07 JUN 07 Rev G
1. INTRODUCTION
This instruction sheet has been prepared to serve as
an applicator conversion guide and, in the process,
promote a better understanding of the typical
differences between semi–automatic (bench) and
automatic versions of miniature and heavy duty (HD)
miniature quick–change applicators. Applicator setup
personnel and those responsible for production
scheduling should find this of particular value—
especially in operations where miniature
quick–change applicators are used in both
semi–automatic (bench) and automatic machines.
NOTE
i
Dimensions in this instruction sheet are in
millimeters [with inches in brackets].
CONVERSION
PART
Stripper
(Side Feed)
SEMI-AUTOMATIC (BENCH) MACHINE
Fixed
Floating
Pin 464661-1
AUTOMATIC MACHINE
With 41.3-mm [1⁵/₈-in.] Stroke
Feed and Eject Sides of Machine
690472-2
Stripper
(End Feed)
Shaft Collar 22292-2
Note: Thicker stripper spacer required
for semi-automatic machine.
Thick
Spacer
Note: Different stripper spacer requirement than
bench machine (thinner or none).
Thin
Spacer
Wire Drops
Straight Down
Note: Same thick spacer as bench machine.
Thick
Spacer
Wire is Moved
Straight Down
Terminal
Feed Cam
(Also See Figure 2)
Machine with 28.6-mm [1¹/₈-in.] Stroke
Pre Feed
Post Feed
Mini 690602-2
HD Mini 690602-5
Mini 690501-1
HD Mini 690501-3
Machine with 41.3-mm [1⁵/₈-in.] Stroke
Long Pre Feed
Mini 690602-6
HD Mini 690602-6
Long Post Feed
Mini 238015-1
HD Mini 690501-4
Strip Guide
Cover Plate
Not Used
Long Post Feed
Mini 238015-1
HD Mini 690501-4
Eject Side of Machine
(Side Feed Only)
454877-[ ]
Front Chip Guard
Sometimes Used on Semi-Automatic and Automatic Machines (Side Feed Only)
691667-[ ]
Figure 1
E2007 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 3
LOC B