English
Language : 

408-7384 Datasheet, PDF (1/2 Pages) Tyco Electronics – Reasons for reissue of this instruction sheet are provided in Section 6, REVISION SUMMARY.
Flexible Flat Cable
(FFC)
Extraction Tools 91047-[ ]
Instruction Sheet
408-7384
11 MAY 10 Rev A
Outer Edge of Connector Housing
(Single-Row Connector Shown)
Locking Lance Slot
Extraction Tool
(Ref)
Locking Lance
Blade
Figure 1
1. INTRODUCTION
Extraction Tools 91047-[ ] are designed to extract
flexible flat cable (FFC) contacts from FFC pin,
receptacle, and edge connectors with end entrance
locking lance slots (reference part number 86670-8).
Read these instructions thoroughly before removing
any contacts.
For connectors with side entrance locking lance slots,
refer to 408-7916 for Tool 91200-[ ].
NOTE
i
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures are
not drawn to scale.
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.
2. DESCRIPTION
Each tool features a specific number of tool blades
that release the contact locking lances of the
connector. See Figure 1. The number of tool blades
must match the number of cavities in one row of the
connector.
CAUTION
All contact locking lances must be released
simultaneously; otherwise, damage to the
!
connector, contacts, or cable may result.
3. EXTRACTION PROCEDURE
Refer to Figure 2, and ensure that the number of
blades of the extraction tool matches the number of
contact cavities in one row of the connector.
EXTRACTION TOOL
PART NUMBER
NUMBER OF BLADES
0-91047-1
09
0-91047-2
19
0-91047-3
29
0-91047-5
20
1-91047-0
10
1-91047-2
35
1-91047-4
12
1-91047-5
14
1-91047-6
15
1-91047-8
05
1-91047-9
03
2-91047-6
06
Figure 2
Proceed as follows:
1. Align the tool blades with the locking lance
slots located between the contacts and outer
edge of the housing as shown in Figure 1.
2. Simultaneously insert all tool blades straight
into the connector until the tool bottoms. Only the
radius between the tool blades should be visible
when the tool is properly seated. See Figure 3.
3. Holding the tool and connector in one hand,
carefully pull on the cable. A slight side-to-side
motion may be used to ease contact extraction.
©2010 Tyco Electronics Corporation, Berwyn, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All Rights Reserved
TE logo and Tyco Electronics are trademarks.
PRODUCT INFORMATION 1-800-522-6752
*Trademark. Other products, logos, and company names might be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 2
LOC B