408-4785 Datasheet, PDF (1/2 Pages) Tyco Electronics – This instruction sheet contains the assembly

Lock
Washer
SSMA Bulkhead Feedthrough Jack
Connector (Crimp Attachment)
Dielectric
Inner Sleeve
Assembly
Instruction Sheet
408-4785
07 MAY 07 Rev A
Sheath
Clamp
Nut
Housing
Assembly
Center
Contact
Outer Sleeve
Tyco Electronics
Part Number
Previous Part
Number
Description
Cable Type
1045506-1
1034 7196 02
SSMA Bulkhead Feedthrough Cable Jack Connector
(Crimp Attachment)
RG178/U, 196
1. INTRODUCTION
This instruction sheet contains the assembly
Figure 1
an outer sleeve, and a sheath (shrink tubing). See
Figure 1.
procedure for the SSMA Bulkhead Feedthrough
Cable Jack Connector shown in Figure 1. This
connector is a crimp attachment type connectors that
attaches to the cable listed in Figure 1.
3. ASSEMBLY PROCEDURE
DANGER
Follow safety precautions included with the tools
The table in Figure 2 references the tooling used to
apply this connector. The table includes tool
used for assembly.
descriptions, the Tyco Electronics part number, and
the corresponding (previous) part number.
1. Place the outer sleeve and sheath on the cable.
Tyco Electronics
Part Number
1055463-1
1055236-1
1055781-1
1055780-1
Previous
Part Number
Description
2098 5237 10
Center Contact Holder
(T-4579)
2098 0105 54
Crimp Tool and Die
2598 5007 54
Hex Crimp Die
2598 5006 54
Crimp Tool
Figure 2
NOTE
i
Dimension on this sheet are in millimeters [with
inches in brackets], unless otherwise specified.
Reasons for revision can be found in Section 4,
REVISION SUMMARY.
DANGER
To avoid personal injury, be sure to use
appropriate safety equipment, including gloves,
when using cable stripping tools.
2. Strip the cable according to the dimension in
Figure 3.
3. Flare the cable braid.
14.274
[.562]
Sheath
2.41
[.095]
7.137
[.281]
Cable
Jacket
2. DESCRIPTION
The SSMA Bulkhead Feedthrough Cable Jack
Connector consists of a housing assembly, a
dielectric, a center contact, an inner sleeve assembly,
Inner
Conductor
Cable Braid
Dielectric
Outer
Sleeve
Figure 3
E2007 Tyco Electronics Corporation, Harrisburg, PA
TOOLING ASSISTANCE CENTER 1-800-722-1111
All International Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 2
LOC B