408-4379 Datasheet, PDF (1/5 Pages) Tyco Electronics – PRO-CRIMPER* III Hand Crimping

PRO- CRIMPER* III Hand Crimping
Tool Assembly 58641- 1 with
Die Assembly 58641- 2
Instruction Sheet
408- 4379
18 JUN 09 Rev A
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- use, production operations is available.
Locator Assembly
(Supplied with
Die Assembly)
Front of Tool
(Locator Side)
Stationary Jaw
Back of Tool
(Wire Side)
Pivot Pin
Die Assembly
Moving Jaw
PRO- CRIMPER III Hand
Crimping Tool Frame
354940- 1 ( 408- 9930)
Ratchet Adjustment Wheel
The PRO- CRIMPER III Hand Crimping Tool is a “Commercial” grade tool and
is designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in
the appropriate 114 series specification, but may not comply with other feature
parameters of the specification. Tyco Electronics offers a variety of tools to
satisfy your performance requirements. For additional information, contact the
Tooling Assistance Center at 1- 800- 722- 1111.
Stationary Handle
Moving Handle
TE Die Assembly Locator Assembly{ Contact Family}
Size
(AWG)
Wire
Insul Dia
(mm [in.])
Strip Length
(mm [in.])
58641--2
58516--1
AMPMODU* IV
26 -- 24
22
1.02 -- 1.52
[.040 -- .060]
4.37 -- 3.58
[.172 -- .141]
{ Supplied with die assembly, also available separately.
Figure 1
} Contact the Tooling Assistance Center or the Product
Information Center (see below) for specific contact part numbers.
1. INTRODUCTION
PRO--CRIMPER III Hand Crimping Tool Assembly
58641--1 consists of Die Assembly 58641--2 and
PRO--CRIMPER III Hand Crimping Tool Frame
354940--1. The die assembly consists of crimping
dies and a locator assembly.
Read these instructions thoroughly before crimping
any contacts.
Reasons for revision can be found in Section 11,
REVISION SUMMARY.
NOTE
i
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
and illustrations are for identification only and are
not drawn to scale.
2. DESCRIPTION (Figures 1 and 2)
The tool features a tool frame with a stationary jaw
and handle, a moving jaw, a moving handle, and an
adjustable ratchet that ensures full contact crimping.
The tool frame holds a die assembly with two
crimping sections.
The die assembly features a wire anvil, an insulation
anvil, a wire crimper, and an insulation crimper.
E2009 Tyco Electronics Corporation, Harrisburg, PA TOOLING ASSISTANCE CENTER 1- 800- 722- 1111
All International Rights Reserved
PRODUCT INFORMATION 1- 800- 522- 6752
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
1 of 5
LOC B